YSP-3000/YSP-30D/HTY-7030
19
YSP-3000/YSP-30D/
HTY-7030
8. Press the [E.P.R.] button, the screen appears as shown
below. (Fig. 5)
Press the [OK] button and start writing. (Fig. 5)
8.[E.P.R]ボタンを押すと、下記の画面が表示されます。
(Fig. 5)
[OK]ボタンを押し、書き込みを開始します。(Fig. 5)
7. Press the [Setting] button and set the baud rate. (Fig. 4) 7.[Setting]ボタンを押し、通信速度の設定を行います。
(Fig. 4)
6. Press the [Refer...] button. And select the firmware
name. (Fig. 3)
* The ID code and MCU type are
loaded when the file is se-
lected. (Fig. 3)
Press the [OK] bottom. (Fig. 3)
6.[Refer...]ボタンを押し、書き込むファームウェアを選
択します。(Fig. 3)
※ ID、およびMCU Typeは書き込みファイル
選択時、自動的に取り込まれます。(Fig. 3)
[OK]ボタンを押します。(Fig. 3)
Fig. 3
Select 115200bps or below for the baud rate.
* Reduce the baud rate if a transmission error occurs fre-
quently.
通信速度は115200bps以下を選択します
※ 送信エラーが多発する場合は、通信速度を下げてくだ
さい。
Fig. 4
Press this button to open
the window
このボタンを押すと
ウィンドウが開きます
Fig. 5
Writing being executed.
書き込み中
Comments to this Manuals