Yamaha DSP-A2070 Owner's Manual download pdf (Page 13)

1 GND Terminal

Connects the ground wire of the turntable to produce minimum

hum. In some cases, however, better results may be obtained

with the ground wire disconnected.

2 Audio Signal Connection Jacks (for Audio Source Equipment)

Connect the inputs and/or outputs of your audio equipment.

3 Audio/Video Signal Connection Jacks (for Video Source

Equipment)

Connect the audio and video inputs and/or outputs of your video

equipment. In place of the VIDEO jacks, the S VIDEO jacks can

be used for higher resolution and improved picture quality if your

VCR, monitor, etc. are equipped with S-VIDEO connectors.

4 Main Speaker Terminals

When using this unit’s built-in main-channel amplifier, connect the

main speakers here. The jumper bars must be plugged in to

connect the MAIN IN jacks to the MAIN OUT jacks.

5 Front Effect Speaker Terminals

When using the built-in front-channel amplifier, connect the front

effect speakers here.

6 Center Speaker Terminals

When using the built-in center-channel amplifier, connect one or

two center speakers here.

7 Center Speaker Impedance Switch

Set to “A + B” when using two center speakers, or to “A or B”

when using only one center speaker.

8 Rear Effect Speaker Terminals

When using the built-in rear-channel amplifier, connect the rear

effect speakers here.

9 Video NTSC/PAL Switch (General Model only)

Set this switch to the position corresponding to the standard

that your video equipment employs.

0 Front Mix Switch

Set to “OFF” when setting up a full 7 or 6 speaker system, or to

“ON” when setting up a 5 or 4 speaker system.

A Main Level Control

Adjusts the main-channel line output level at the MAIN OUT

jacks. Used to achieve balance between the main and effect

speakers.

B Main Out Jacks

Main-channel line output. Connected with jumper bars to MAIN

IN jacks when the built-in amplifier is used. Connected to input

jacks of external stereo power amplifier (MAIN IN or TAPE PLAY

jacks of integrated amplifier or receiver) when using external

amplification.

C Main In Jacks

Line input to built-in main-channel amplifier. Connected with

jumper bars to MAIN OUT jacks when the built-in amplifier is

used. Not connected when using an external power amplifier.

D Center Out Jacks

Center-channel line outputs. Not connected when the built-in

amplifier is used. Can be connected to input jack(s) of one or two

external power amplifier(s) to drive the center speaker(s).

1 ... 12 13 14 ... 56

Comments to this Manuals

No comments

Yamaha DSP-A2070 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for AV receivers Yamaha DSP-A2070