Yamaha CVP-609 Owner's Manual download pdf (Page 94)

CVP-609/605 Owner’s Manual

CVP-609 (Grand piano type) Assembly

2 Attach two front legs and a rear leg.

Refer to the diagram below to verify the orientation of the

legs.

Install and tighten four screws on each leg, starting with

one of the front legs.

3 Install the pedal box.

1 Remove the twist tie that affixes the pedal cord to the upper

portion of the pedal box.

2 Align the cord with the groove on the unit, and attach the

pedal box using four screws.

3 Insert the pedal cord plug into the pedal connector.

Insert the plug into the connector so that the side with the

arrow mark is facing forward (keyboard side). If the plug

does not fit easily do not try to force it, but check the plug

for correct orientation, and then reinsert it into the

connector.

Insert the pedal cord securely until the metal part of the

cord plug disappears from view. Otherwise, the pedal may

not function properly.

4 Attach the cord holder on the unit as shown in the

illustration below, then use the cord holder to affix the

pedal cord.

4 Raise the unit to the standing position.

Use the front legs as support to raise the unit.

CAUTION

• Be careful not to pinch your fingers.

• When you raise the unit, do not hold the key cover.

Rear leg

Front leg Front leg

6 x 40 mm fixing screws

Twist tie

6 x 20 mm fixing screws

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 116 117

No comments

Yamaha CVP-609 Owner's Manual Page 94