Yamaha CVP-609 Owner's Manual download pdf (Page 99)

CVP-609/605 Owner’s Manual

CVP-605 Assembly

CAUTION

• Assemble the unit on a hard and flat floor with ample space.

• Be careful not to confuse or misplace the parts, and be sure to

install all parts in the correct orientation. Please assemble the

unit in accordance with the sequence described here.

• Assembly should be carried out by at least two persons.

• Be sure to use only the included screws of the specified sizes.

Do not use any other screws. Use of incorrect screws can cause

damage or malfunction of the product.

• Be sure to tighten all screws upon completing assembly of each

unit.

• To disassemble the unit, reverse the assembly sequence.

Remove all parts from the package and make sure you have all

of the items.

1 Attach units D and E to unit C.

1 Untie and straighten out the bundled pedal cord.

You will need the vinyl tie later in step 5.

2 Attach units D and E to unit C by tightening four long

screws (6 x 20 mm).

2 Attach unit B to the above assembly.

1 Align the screw holes on the upper side of unit B with the

bracket holes on units D and E, then attach the upper

corners of unit B to units D and E by manually tightening

two thin screws (4 x 12 mm).

2 Secure the bottom end of unit B using four tapping screws

(4 x 20 mm).

3 Securely tighten the screws on the top of unit B that were

attached in step 2-

3 Mount unit A on the above assembly.

Be sure to place your hands at least 15 cm from either end

of the main unit when positioning it.

CAUTION

• Be extra careful not to drop the unit or let your fingers be

pinched by the main unit.

• Do not hold the main unit in any position other than the position

specified here.

Have a Phillips-head (+) screwdriver of the appropriate size ready.

To prevent damage to the speaker box located at the bottom of unit A,

make sure to place unit A on the styrofoam pads. Also, make sure that

the pads do not touch the speaker box.

Bundled pedal cord inside here.

6 x 20 mm long screws (4)

6 x 16 mm short screws (6)

4 x 12 mm thin screws (2)

4 x 20 mm tapping screws (4)

Cord holders (2)

Headphone hanger

Power cord

4 x 10 mm

thin screws (2)

Align the

screw holes.

15 cm distance or further

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 116 117

Comments to this Manuals

No comments

Yamaha CVP-609 Owner's Manual Page 99

Comments to this Manuals

Related products and manuals for Synthesizer Yamaha CVP-609