Yamaha Amp Editor Owner's Manual download pdf (Page 134)

Chapter 8 Device Properties window

Amp Editor Owner’s Manual

134

 [Output Alert] tab

Here you can make settings such as the threshold values for the amplifier’s maximum output. These settings can

be changed when online or offline. Specifying the impedance allows you to detect whether the output without the

pilot tone is disconnected or shorted.

• The [Calibration by Program Source...] button is available only when online.

• In the [Output Signal Chain Check] tab (page 137), you can make settings concerning detection for dis-

connection or shorting of the output with the pilot tone.

The settings are the same for Speaker Output and Slot Output Level (TXn only).

q [Calibration by Program Source...] button (TXn only)

In the “Calibration by Program Source” dialog box, you can specify calibration of the Max/Min Threshold of

the Speaker Output’s Impedance.

• Completing measurement takes about ten seconds.

• Depending on the character of the Program Source, it may be not properly measured.

• If the Program Source level is low, it may be not properly measured.

• If the output level is lowered by the attenuator, it may be not properly measured.

w Check box

Specifies whether alert detection will be enabled or disabled. If a point exceeding the specified value (Thresh-

old) is detected for the specified number of times (Count) within the specified duration (Detection Time), it

will be determined that an alert has occurred. Detection is in 2 ms intervals.

Check boxes in the Slot Output Level area enable/disable Level.

NOTE

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 210 211

No comments

Yamaha Amp Editor Owner's Manual Page 134