Yamaha Amp Editor Owner's Manual download pdf (Page 143)

Amp Editor Owner’s Manual

143

Chapter

Component editor (TXn only)

When you click a component that has been placed in the Signal Path View window, the component editor

window will open. The component editor allows you to edit detailed parameters for the component.

Objects in the window and their function

• The content of the window as well as the name shown in the title bar will depend on the type of compo-

nent.

 Title bar

Shows the name of the component.

 Snap

This lets you temporarily store up to four parameter sets for the component editor (page 150).

Click a button to switch parameter sets. You can copy a parameter set by dragging and dropping a button onto

another button. You can also copy a parameter set by using the context menu that appears when you right-

click a button.

 Knob

Drag a knob to edit its parameter. The mode of knob operation will depend on the “Preferences” dialog box

setting [Component Editor] tab  [Knob Mode] (page 39).

• To make fine adjustments, drag while holding down the <Shift> key when [Knob Mode] is [Linear].

To reset a parameter to its default value, hold down the <Ctrl> key and click.

Title bar

Snap

Edit box

Knob

Button

NOTE

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 210 211

No comments

Yamaha Amp Editor Owner's Manual Page 143