Yamaha DVD-C920 Owner's Manual download pdf (Page 11)

[] Turn the remote control over and slide the

battery compartment cover in the direction of

the arrow.

[] Insert the batteries (AA, R06, UM-3 type)

according the polarity markings on the inside

of the battery compartment.

[] Close the battery compartment cover.

If the remote control operates only when it is close to the unit, the batteries are weak. Replace all the batteries with new ones.

• Use only AA, R06 or UM-3 batteries for replacement.

• Be sure the battery polarity is correct. (See the illustration inside the battery compartment.)

• Remove the batteries if the remote control will not be used for an extended period of time.

• If the batteries have leaked, dispose of them immediately. Avoid touching the leaked material or letting it come into contact with

clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

0 0 0................................. 0

_"_@@@

Within approximately 6 m

(20feet)

The remote control transmits a directional infrared beam. Be

sure to aim the remote control directly at the infrared sensor

during operation. When the sensor is covered or there is a

large object between the remote control and the sensor, the

sensor cannot receive signals. The sensor may not be able to

receive signals properly when it is exposed to direct sunlight

or a strong artificial light (such as a fluorescent or strobe

light). In this case, change the direction of the light or

reposition the unit to avoid direct lighting.

• Handle the remote control with care.

• Do not spill water, tea or other liquids on the remote control.

• Do not drop the remote control.

• Do not leave or store the remote control in the following

conditions:

- high humidity or temperature such as near a heater, stove or

bath;

- dusty places; or

- extremely low temperature.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

No comments

Yamaha DVD-C920 Owner's Manual Page 11