Yamaha YHT-296 Manual download pdf (Page 65)

En 65

APPENDIX

Troubleshooting

AM

Remote control

Problem Cause Remedy

See

page

The desired station

cannot be tuned into

with the automatic

tuning method.

The signal is weak, or the antenna

connections are loose.

Adjust the AM loop antenna orientation. 20

Use the manual tuning method. 30

Automatic station

preset does not

work.

Automatic station preset is not

available for AM stations.

Use manual station preset. 32

Continuous

crackling and

hissing noises are

heard.

The supplied AM loop antenna is

not connected.

Connect the AM loop antenna correctly

even if you use an outdoor antenna.

20

The noises may be caused by

lightning, fluorescent lamps,

motors, thermostats, or other

electrical equipment.

It is difficult to completely eliminate noise,

but it can be reduced by installing and

properly grounding an outdoor AM antenna.

20

Buzzing and whining

noises are heard.

A TV set is being used nearby. Move this unit away from the TV set. —

Problem Cause Remedy

See

page

The remote control

does not work or

function properly.

Wrong distance or angle. The remote control will function within a

maximum range of 20 ft / 6 m, and no more

than 30 degrees off-axis from the front

panel.

—

Direct sunlight or lighting (from

an inverter type of fluorescent

lamp, strobe light, etc.) is striking

the remote control sensor of this

unit.

Adjust the lighting angle, or reposition this

unit.

—

The batteries are weak. Replace all batteries. 4

The remote control ID of the

remote control and this unit do not

match.

Match the remote control ID of this unit and

the remote control.

57

External components

cannot be controlled

using the remote

control.

The remote control code is not

correctly set.

Set the remote control code correctly using

“Remote control code search” on the CD-

ROM.

—

Try setting another code for the same

manufacturer using “Remote control code

search” on the CD-ROM.

—

If this unit does not work when you press

jCursor B / C / D / E (on the remote

control), do the following.

When the key does not work during DVD

disc menu operation: press the dInput

selector (on the remote control) again.

—

When the key does not work during Option

menu/Setup menu operation: press the key

corresponding to the current menu operation

again.

Even if the remote control code is correctly

set, there are some models that do not

respond to the remote control.

—

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 71 72

Comments to this Manuals

No comments