Yamaha YHT-296 Manual download pdf (Page 62)

En 62

APPENDIX

Troubleshooting

No sound. Incorrect input or output cable

connections.

Connect the cables properly. If the problem

persists, the cables may be defective.

15

If a DVI-HDMI cable is used to

connect the unit with an external

component, then it is necessary to

use an audio input jack for a

different input to output audio.

Display the HDMI Input Option menu for

the connected cable, select “Audio In,” and

select the jack to use for audio input.

40

Speaker connections are not

secure.

Secure the connections. 11

The HDMI components connected

to the unit do not support the

HDCP copy protection standards.

Connect HDMI components that support the

HDCP copy protection standards.

40

The audio input into the device is

set to playback through the TV.

In the Setup menu, set the HDMI Audio Out

(“HDMI Setup” → “Audio”) to other than

“TV.”

48

No appropriate input source has

been selected.

Select an appropriate input source with

dInput selector (on the remote control).

25

The volume is turned down or

muted.

Turn up the volume. —

Signals that this unit cannot

reproduce are being input from a

source component, such as a CD-

ROM.

Use an input source that has signals that can

be reproduced on this unit.

—

No picture. A video jack (ex. Video input →

HDMI output) type different to the

input video is being used to try to

display content on the TV.

Use video jacks of the same type (ex. Video

input → Video output) to connect to the TV.

13

An appropriate video input is not

selected on the TV.

Select an appropriate video input on the TV. —

Problem Cause Remedy

See

page

No sound is output

from a specific

speaker.

The speaker is malfunctioning.

Check the Speaker indicators on

the front panel display. If the

corresponding indicator lights up,

connect another speaker and check

if sound is output.

If sound is not output, the unit may be

malfunctioning.

7

The playback component or

speakers are not connected

properly.

Connect the cables properly. If the problem

persists, the cables may be defective.

11, 15

Output from that speaker is

disabled.

Check the Speaker indicators on the front

panel display. If the corresponding indicator

is turned off, try the following.

1) Change to a different input source.

2) With the selected sound field program,

sound is not output from that speaker. Select

another sound field program.

3) “None” may have been selected for that

speaker on this unit. Display “Speaker

Setup” in the Setup menu, and set respective

parameters to enable output from that

speaker (“Speaker Setup” → “Config”).

7, 43

The volume of that speaker is set

to the minimum in “Speaker

Setup” in the Setup menu.

Display “Speaker Setup” in the Setup menu

and adjust the volume (“Speaker Setup” →

“Level”).

44

(If hardly any sound comes from

one channel)

Speaker output balance is not set

correctly.

Balance the volume of each speaker from

“Level” in the Setup menu (“Speaker Setup”

→ “Level”).

44

Sound may not be output from

certain channels, depending on the

input source or sound field

program.

Try another sound field program. 26

Only the center

speaker outputs

substantial sound.

When a monaural source sound

field program is applied, for some

surround decoders, sound from all

channels is output from the center

speaker.

Try another sound field program. 26

Problem Cause Remedy

See

page

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 71 72

Comments to this Manuals

No comments