Yamaha MG8 Manual download pdf (Page 18)

Front & Rear Panels

MG8/2FX

Input/Output Section

1 Channel Input Jacks (CHs 1, 2, 3/4, 5/6)

• MIC jacks

These are balanced XLR-type input jacks (1:Ground;

2:Hot; 3:Cold).

• LINE jacks

These are balanced phone-type input jacks. You can

connect either balanced or unbalanced phone plugs to

these jacks.

Where an input channel provides both a MIC jack

and a LINE jack, you may use either one of these

jacks but you may not use both at the same time.

Please connect to only one of these jacks on each

channel.

2 INSERT I/O Jacks (CHs 1 and 2)

These are unbalanced phone-type input/output jacks.

Each of these jacks is positioned between the equalizer

and Channel LEVEL Control of the corresponding input

channel. These jacks can be used to independently con-

nect these channels to devices such as graphic equalizers,

compressors, and noise ﬁlters. These are TRS (tip, ring,

sleeve) phone jacks that support bidirectional operation.

Connection to an INSERT I/O jack requires a spe-

cial separately-sold insertion cable such as illus-

trated below.

The signal output from the INSERT I/O jacks is

reverse-phased. This will not be a problem if con-

necting the jack to an effector. If using the jack to

output to an external device, however, please be

aware of possible phase conﬂicts with other signals.

3 Channel Input Jacks (CH 7/8)

Each of these channel pairs can be used to input a stereo

source signal. For each pair, the odd-numbered channel

inputs the L signal, and the even-numbered channel

inputs the R signal.

Each channel offers a choice of two jack types: phone

jack and RCA pin jack. All of these jacks are unbal-

anced.

Where a channel provides both a phone jack and

an RCA pin jack, you may use either one of these

jacks but you may not use both at the same time.

Please connect to only of these jacks on each chan-

nel.

4 2TR IN Jacks

These are unbalanced RCA-pin input jacks. Use these

jacks when you want to connect a stereo sound source

(CD, DAT, etc.) directly to the mixer for monitoring.

You can adjust the signal level using the 2TR IN

control in the Master Control section.

5 REC OUT (L, R) Jacks

These are unbalanced RCA-pin output jacks. These jacks

output the mixed signal whose level is controlled by the

ST Master LEVEL Control. You use these jacks, for

example, to connect to an external recorder.

28790

13 A456

NOTE

To the INSERT I/O jack

To the input jack of the external processor

To the output jack of the external processor

Ring

Sleeve

Tip

Sleeve

Tip

NOTE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Comments to this Manuals

No comments

Yamaha MG8 Manual Page 18

Comments to this Manuals

Related products and manuals for Audio mixers Yamaha MG8