Yamaha MG8 Manual download pdf (Page 16)

Front & Rear Panels

MG8/2FX

Master Control Section

1 PHANTOM +48 V Switch

This switch toggles phantom power on and off. If you set

the switch on, the mixer supplies power to all channels

that provide XLR mic input jacks (CHs 1, 2, 3/4, 5/6).

Set this switch on ( ) when using one or more con-

denser microphones.

When this switch is on, the mixer supplies DC

+48 V power to pins 2 and 3 of all XLR-type MIC

INPUT jacks.

• Be sure to leave this switch off ( ) if you do not

need phantom power.

• When tuning the switch on ( ), be sure that

only condenser mics are connected to the XLR

input jacks (CHs: 1 to 5/6). Devices other than

condenser mics may be damaged if connected to

the phantom power supply. Note, however, that

the switch may be left on without problem when

connecting to balanced dynamic microphones.

• To avoid damage to speakers, be sure to turn off

ampliﬁers (or powered speakers) before turning

this switch on or off. We also recommend that you

turn all output controls (ST Master LEVEL Con-

trol, etc.) to minimum settings before operating

the switch, to avoid risk of loud noises that could

cause hearing loss or device damage.

2 RETURN Control

Adjusts the level of the signal sent from the RETURN

jacks (L (MONO) and R) to the Stereo bus.

If you supply a signal to the RETURN L (MONO)

jack only, the mixer outputs the identical signal to

both the L and R Stereo buses.

3 2TR IN Control

Adjusts the level of the signal sent from the 2TR IN jack

to the Stereo bus.

4 ST Master LEVEL Control

Adjusts the signal level to the ST OUT jacks.

5 C-R/PHONES LEVEL Control

Controls the level of the signal output to the PHONES

jack and the C-R L and R jacks.

6 Level Meter

This LED display shows the level of the signal fed to the

Stereo bus. The “0” point corresponds to the standard

output level. The indicator lights up red when the output

hits the clipping level.

7 POWER Indicator

This indicator lights up when the mixer’s power is ON.

8 DIGITAL EFFECT

•PROGRAM Dial

Selects the internal digital effect to be applied. You can

select from 16 effects, as shown in the table.

REVERB HALL 1

REVERB HALL 2

REVERB ROOM 1

REVERB ROOM 2

REVERB STAGE 1

REVERB STAGE 2

REVERB PLATE

DRUM AMBIENCE

KARAOKE ECHO

VOCAL ECHO

CHORUS 1

CHORUS 2

FLANGER

PHASER

AUTO WAH

DISTORTION

NOTE

No Program Parameter

REVERB HALL 1 REVERB TIME

REVERB HALL 2 REVERB TIME

REVERB ROOM 1 REVERB TIME

REVERB ROOM 2 REVERB TIME

REVERB STAGE 1 REVERB TIME

REVERB STAGE 2 REVERB TIME

REVERB PLATE REVERB TIME

DRUM AMBIENCE REVERB TIME

KARAOKE ECHO DELAY TIME

VOCAL ECHO DELAY TIME

CHORUS 1 LFO FREQ

CHORUS 2 LFO FREQ

FLANGER LFO FREQ

PHASER LFO FREQ

AUTO WAH LFO FREQ

DISTORTION DRIVE

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Yamaha MG8 Manual Page 16

Comments to this Manuals

Related products and manuals for Audio mixers Yamaha MG8