KENTON PLUGSTATION USERS MANUAL
35
THESE COMMANDS CAN BE SYSEX CONTROLLED, WITH THE SYSEX FOR EACH LEVEL LISTED
(ALONG WITH SYSEX FOR ALL OTHER PLUGSTATION PARAMETERS) AT THE BACK OF THIS
MANUAL. SPECIFIC PLUGSTATION SUPPORT SOFTWARE SUCH AS XGPAD (WWW.XGPAD.COM
)
CAN SUPPORT THESE PARAMETERS, AND IT IS STRONGLY ADVISED THAT YOU DOWNLOAD
THIS SOFTWARE (OR OTHER SUITABLE APPLICATIONS ON RELEASE) TO SUPPORT CONTROL OF
PLG CARD VOLUMES IN PLUGSTATION. IF YOU ARE HAPPY WITH STATIC VOLUME LEVELS, THEN
FRONT PANEL CONTROL AND SETUP WILL BE OKAY, HOWEVER IF YOU WISH TO ADJUST
VOLUMES OF BOARDS DYNAMICALLY (FOR EXAMPLE IN A SONG ON YOUR SEQUENCER) THEN
SOFTWARE SUPPORT OR AN APPROPRIATE MEANS OF CONTROL (SUCH AS THE KENTON
CONTROL FREAK) IS REQUIRED.
YVOL – THIS IS THE Y-BOARD INDIVIDUAL PLG CARD OUTPUT VOLUME.
This parameter is only
effective if you have the optional Y-BOARD fitted to your PLUGSTATION. It controls the output level for
each PLG card to the respective individual output you may have assigned them to. It is in effect an individual
output level control for the PLG cards. The value range for this is 0-127
(0 is off, 127 is full volume).
It is
worth also checking that if you have the individual outputs (ADAT or Analogue) connected to your mixing
desk, that the channels on your mixing desk are switched on, and that you remember if you have both the
ADAT and the analogue outputs connected at the same time that this YVOL control, controls the levels
being sent for each board to both (The ADAT and analogue outputs are being fed from the same primary
DSP and wired in parallel).
YBAL – THIS IS THE Y-BOARD INDIVIDUAL PLG CARD BALANCE CONTROL.
This parameter is only
effective if you have the optional Y-BOARD fitted to your PLUGSTATION. It controls the output balance for
each PLG card to the respective individual output you may have assigned them to. It is an individual panning
control to the Y-BOARD outputs from each of the PLG cards.
The value range for this is 0-127, with a
default value of 64
(0 is full left, 127 is full right, 64 is center panning).
It is worth also checking that if
you have the individual outputs (ADAT or Analogue) connected to your mixing desk, that the channels on
your mixing desk are panned accordingly as well, as if the inputs on your mixer are panned center then you
may not hear any effect from this control. Also remember that if you have both the ADAT and the analogue
outputs connected at the same time that this controls the panning levels being sent for each board to both.
This control allows you to set boards which you may only wish to hear in MONO to discrete outputs. For
example, if you set the PLG150VL card to pan hard left (value 0) in slot 1, and have it set to output to Y-
BOARD outputs 1&2, you will only actually hear it from output 1 (1,3,5 and 7 are treated as LEFT – 2,4,6
and 8 as right)
(43 pages)
(34 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals