Yamaha SW1000XG Owner's Manual download pdf (Page 17)

KENTON PLUGSTATION USERS MANUAL

The brackets are arranged to allow two cards at each level, one towards the front and one towards the rear.

Correctly fitting the cards is quite a delicate operation, but once installed, you should not have to remove or

tamper with cards again. (See diagram 11)

DIAGRAM 11: FITTING PLG CARDS

When you have attached and fitted each card correctly, you may replace the back cover with the attachment

screws, and reconnect all power and audio cables to the PLUGSTATION. Please remember to fit the back

plate back on securely as this is also an EM (electro magnetic) interference shield which will stop EM

leakage from the inside of the unit.

To check that you have correctly installed the cards into the slots, you have intended, turn on the power to

PLUGSTATION, and allow it to run through its initialization sequence (remember to press the DATA ENTRY

knob if you wish it to go into stand alone mode the first time you turn it on). During the sequence it will scan

the 4 card slots for new boards. If it detects a PLG card in a slot it will briefly flash the SLOT number up

before dropping to the CARD ACTIVE led display, which also indicates the presence of a card in a specific

slot (see diagram 2). If no card is found, please repeat the installation process carefully checking that the

PLG connector cables are securely in place, and that the cards are correctly inserted into the brackets. For

example is you have correctly fitted cards into slots 1,2 and 3 but not 4 you will see a display flash up similar

to diagram 12.

DIAGRAM 12: SLOTS 1,2 AND 3 HAVE CARDS FITTED, AND DISPLAYED DURING POWER UP

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 87 88

No comments

Yamaha SW1000XG Owner's Manual Page 17