Yamaha EMX62M Owner's Manual download pdf (Page 14)

12 Front & Rear Panels

EMX62M—Owner’s Manual

Input/Output Panel

1 Hi-Z, Low-Z (inputs 1–4)

These are the input connectors for input chan-

nels 1 through 4.

Both the Hi-Z and Low-Z input can be used with

microphones and, by using the PAD switch (con-

trol panel 5), can also be used with line-level

sources, such as synthesizers and drum machines.

Switchable +15 V phantom power is available to

the Low-Z XLR-type input for use with con-

denser-type microphones.

Both the Hi-Z and Low-Z inputs are balanced.

Pin connections are as follows.

B LINE 1 & 2 (input 5)

These two phone jacks are the input connectors

for input channel 5. They are unbalanced, can be

used simultaneously, and are appropriate for use

with line-level sources, such as synthesizers and

drum machines.

C Super Hi-Z 1 & 2 (input 6)

These two phone jacks are the input connectors

for input channel 6. They are unbalanced, can be

used simultaneously, and their high input imped-

ance makes them ideal for use with instruments

such as electric-acoustic guitar and electric bass.

They can also be used with line-level sources,

such as synthesizers and drum machines.

D EFFECT OUT jack

The EFFECT OUT phone jack outputs the signal

from the EFFECT bus and can be connected to

the input of an external effects processor.

E FOOT SW jack

The FOOT SW jack is used to connect an

optional footswitch, such as the Yamaha FC5,

which can be used to turn the built-in digital

effects processor on and off. The DIGITAL

EFFECT ON switch must be in the ON position

in order to use the footswitch.

F AUX IN—INPUT TO MAIN jack

The AUX IN—INPUT TO MAIN phone jack is

used to feed signals from an external source to

the MAIN bus and can be connected to the out-

put of an external effects processor, for example.

G 2TR IN—INPUT TO MAIN jacks

The 2TR IN—INPUT TO MAIN phono jacks are

used to feed signals from an external source to

the MAIN bus and can be connected to the stereo

outputs of a cassette, DAT, or MD deck.

H REC OUT—OUTPUT jacks

The REC OUT—OUTPUT phono jacks output

the MAIN bus signal prior to the 7-band graphic

equalizer and MASTER level control, and can be

connected to the stereo inputs of a cassette, DAT,

or MD deck for recording.

2

1

3 5

6 7 8 9 0

A

4

Low-Z (XLR-type) Hi-Z (TRS phone jack)

Pin 1: ground Sleeve: ground

Pin 2: hot (+) Ring: cold (–)

Pin 3: cold (–) Tip: hot (+)

Note: The Low-Z and Hi-Z input of each chan-

nel cannot be used simultaneously. Use the in-

put appropriate for the source.

Since phantom power is turned on and off for

inputs channels 1 through 4 simultaneously, in-

put devices that do not require it should be con-

nected to the Hi-Z input when phantom power

is used.

GND

RST

+-

GND

+-

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Comments to this Manuals

No comments