Yamaha EMX62M Owner's Manual download pdf (Page 11)

Front & Rear Panels

9

EMX62M—Owner’s Manual

Front & Rear Panels

Control Panel

■

Channel Section

The channel controls are used to set the EQ,

MONITOR and EFFECT send levels, channel

LEVEL, and PAD for each channel.

1

HIGH & LOW EQ controls

The 2-band equalizer allows you to boost or cut

the low or high frequency range for each channel.

The frequency response is ﬂat when the controls

are in the center (

▼

) position. Rotating clockwise

boosts frequencies, rotating counterclockwise

cuts them.

The center frequencies are as follows:

HIGH: 10 kHz ±15 dB shelving type

LOW: 100 Hz ±15 dB shelving type

B

MONITOR control

The MONITOR control determines the level of

the input signal that is fed to the MONITOR bus

and subsequently the MONITOR OUTPUT jack

(input/output panel

0

).

The MONITOR control is not affected by the

channel’s LEVEL control

4

, since the MONI-

TOR signal is sourced before that control.

C

EFFECT control

The EFFECT control determines the level of the

input signal that is fed to the EFFECT bus and

subsequently the onboard effects processor and

EFFECT OUT jack (input/output panel

4

).

EFFECT bus signals are fed simultaneously to the

onboard effects processor and the EFFECT OUT

jack for use with external effects processors.

The EFFECT bus signals are affected by the chan-

nel’s LEVEL control

4

, since the EFFECT signal

is sourced after the EFFECT control. To send a

channel signal to the EFFECT bus, both the

EFFECT and LEVEL controls must be turned up.

D

LEVEL control

The LEVEL control determines the level of the

input signal that is fed to the MAIN bus and

internal power ampliﬁer.

The MAIN bus signal is routed to the MAIN

OUTPUT jack (input/output panel

9

), SPEAK-

ERS 1 and 2 jacks (rear panel

1

), and PHONES

jack (input/output panel

A

).

E

PAD switch (1–4 only)

The PAD switch attenuates the input signal by

30 dB. When connecting a line-level source to

inputs 1 through 4, or if a microphone signal is

distorted, use the PAD switch to attenuate the

input signal.

1

2

3

4

5

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

Comments to this Manuals

No comments