Yamaha YPDR601 User Manual download pdf (Page 2)

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

—

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.

DO NOT REMOVE COVER (OR BACK).

NO USER-SERVICEABLE PARTS INSIOE.

REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

Explanation of Graphical Symbols

The lightning flash with arrowhead

symbol, within an equilateral triangle, is

intended to alert you to the presence of

uninsulated “dangerous voltage” within

the product’s enclosure that may be of

■ sufficient magnitude to constitute a risk of

electric shock to persons.

The exclamation point within an

equilateral triangle is intended to alert you

to the presence of important operating

and maintenance (servicing) instructions

in the literature accompanying the

appliance.

DANGER

Invisible laser radiation when open and interlock failed or

defeated.

Avoid direct exposure to beam.

CAUTION

Use of controls or adjustments or performance of procedures

other than those specified herein may result in hazardous

radiation exposure.

Laser Diode Properties

• Material: GaAIAs

• Wavelength: 780nm

• Emission Duration: continuous

• Laser Output: max. 44.6pW*

• This output is the value measured at a distance of about

200mm from the objective lens surface on the Optical Pick

up Block.

WARNING: CHEMICAL CONTENT NOTICE!

The solder used in the manufacture of this product contains

LEAD. In addition, the electrical/electronic and/or plastic (where

applicable) components may also contain traces of chemicals

found by the California Health and Welfare Agency (and possibly

other entities) to cause cancer and/or birth defects or other

reproductive harm.

DO NOT REMOVE ANY ENCLOSURE COMPONENTS!

There are no user serviceable parts inside. All service should be

performed by a service representative authorized by Yamaha to

perform such sen/ice.

IMPORTANT MESSAGE: Yamaha strives to produce

products that are both user safe and environmentally “friendly”.

We sincerely believe that our products meet these goals.

However, in keeping with both the spirit and the letter of various

statutes we have included the messages shown above and

others in various locations in this manual.

IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions

contained in this manual, meets FCC requirements.

Modifications not expressly approved by Yamaha may void

your authority, granted by the FCC, to use the product.

IMPORTANT : When connecting this product to accessories

and/or another product use only high quality shielded cables.

Cable/s supplied with this product MUST be used. Follow all

installation instructions. Failure to follow instructions could

void your FCC authorization to use this product in the USA.

NOTE: This product has been tested and found to comply

with the requirements listed in FCC Regulations; Part 15 for

Class “A” digital devices. Compliance with these

requirements provides a reasonable level of assurance that

your use of this product in a commercial environment will not

result in harmful interference with other electronic devices.

However, operation of this product in a residential area is

likely to cause interference in some form. In this case you, the

user, bear the responsibility of correcting this condition.

This product generates/uses radio frequencies and, if not

installed and used according to the instructions found in the

users manual, may cause interference harmful to the

operation of other electronic devices. Compliance with FCC

FCC INFORMATION (U.S.A.)

regulations does not guarantee that interference will not

occur in all installations. If this product is found to be the

source of interference, which can be determined by

turning the unit “OFF” and “ON”, please try to eliminate the

problem by using one of the following measures:

Relocate either this product or the device that is being

affected by the interference.

Utilize power outlets that are on different branch (circuit

breaker of fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient

the antenna. If the antenna lead-in is 300 ohm ribbon lead,

change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory

results, please contact the local retailer authorized to

distribute this type of product. If you can not locate the

appropriate retailer, please contact ’‘Yamaha

Corporation of America. Electronic Sen/ice Division. 6600

Oranqethoroe Ave. Buena Park. CA90620.

The above statements apply ONLY to those products

distributed by Yamaha Corporation of America or its

subsidiaries.

1 2 3 4 5 6 7 ... 41 42

Comments to this Manuals

No comments

Yamaha YPDR601 User Manual Page 2

Comments to this Manuals