Yamaha QR10 Specifications Page 9
- Page / 61
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
3
INOUTINPUTOUTPUTPHONES
MIDI
DC IN
ON OFF
POWER
2: Setting Up: Power & Connections
Power Supply
Your QR10 will run either from an optional AC adaptor or batteries. We recommend the use of the optional Yamaha PA-3
AC Adaptor for most applications. Follow the instructions below according to the power source you intend to use.
■ Using a Power Adaptor
Plug the DC output cable from an optional
Yamaha PA-3 AC Adaptor (available from your
Yamaha dealer) into the DC IN jack on the rear
panel, then plug the adaptor into a convenient wall
AC power outlet.
CAUTION
Do not attempt to use an AC adaptor other
than the PA-3. The use of an incompatible
adaptor may cause irreparable damage to
the QR10, and might pose a serious shock hazard!
Be sure to unplug the AC adaptor from the AC mains
outlet when the QR10 is not in use.
■ Using Batteries
Six 1.5V AA size (SUM-3 or R6P) or equivalent alkaline batteries must first be installed in the battery compartment. Please note
that the average life of a full set of new manganese batteries is approximately one hour or less of continuous playback at maximum
volume. Alkaline batteries may last as long as four hours. Please use an AC power adaptor (see above) wherever possible.
1
Open Battery Compartment Cover
Open the battery compartment cover — located
on the instrument’s bottom panel — by pressing on
the two latches on the cover and pulling outward, as
shown in the illustration.
2 Insert Batteries
Insert the six batteries, being careful to follow
the polarity markings on the bottom panel.
3 Replace Cover
Replace the compartment cover, making sure that it locks firmly in place.
■ When to Replace the Batteries
When the batteries run down and are no longer
able to operate the QR10, playback or recording will
stop and the display shown to the right will appear:
If the battery voltage drops too low to maintain the
error display, a random, meaningless display will appear.
When these displays appear, replace the batteries
with a complete set of six new batteries. NEVER
mix old and new, or different type of batteries!
CAUTION
Never unplug the AC adaptor from the QR10 when a set of batteries is installed and the power is turned ON. Turn the power
OFF first.
CAUTION
To prevent possible damage due to battery leakage, remove the batteries from the instrument if it is not to be used for an
extended period of time.
PA-3
- Bescheinigung des Importeurs 2
- PLEASE KEEP THIS MANUAL 3
- SPECIAL MESSAGE SECTION 3
- ■ Contents 4
- ■ Precautions 5
- ■ About This Manual 6
- Features 7
- Applications 7
- QR10 System Overview 8
- Power Supply 9
- Setting Up Your System 10
- ■ Audio Connections 11
- ■ Setting the Input Gain 11
- 3: The QR10 Controls 12
- Play the Demo 15
- 1 Select the Pattern Mode 16
- 2 Select a Pattern Number 16
- 4 Start Playback 17
- 5 Stop Playback 17
- Using the Pattern Variations 18
- Changing the Tempo 19
- Changing Chords 20
- 3 Stop playback when done 21
- Turning Tracks On and Off 22
- 5: More Creative Control 23
- ■ The RHYTHM track 24
- Change the Octave As Required 24
- Voice Sampling 25
- 5 Check the Recorded Sample 26
- Transposition 27
- Making Your Patterns Swing 28
- 6: Playing the Preset Songs 29
- 2 Start Playback 30
- ■ Repeat Playback 30
- 1 Engage the REPEAT Function 31
- 2 Turn REPEAT ON or OFF 31
- ■ Volume Settings in the SONG 31
- The PHRASE Keys 32
- Setting the Phrase Volume 33
- 7: Recording Original Songs 34
- 5 Select a Section 35
- 6 Set the Record Tempo 35
- 7 Enter the Starting Chord 35
- 8 Start Recording 35
- Overdubbing 36
- Recording a MELODY Track 36
- 5 Start Recording 37
- 6 Stop Recording 37
- 4 Start Recording 39
- 5 Stop Recording 39
- Song Clear 40
- Song Copy 41
- 1 Select the PATTERN Mode 42
- 3 Select a Section 42
- Recording the User Patterns 43
- 5 Select a Track to Record 44
- 6 Select a Voice 45
- 7 Select a Chord 45
- 10 Stop Recording 46
- Pattern Copy 47
- 5 Press [START/STOP] to Copy 48
- 9: MIDI Utilities 49
- MIDI Synchronization Mode 50
- The QR10 as an ABC Expander 50
- ■ ABC: MIDI ABC Mode ON/OFF 51
- ■ Appendix 52
- Rhythm Voice List 53
- Troubleshooting 54
- Error Messages 54
- Specifications 55
- MIDI Data Format 56
- Appendix (continued) 57
- MIDI IMPLEMENTATION CHART 58
- ■ Index 59
- VQ78880 JDAHR1CMS15.2 ITP 60
- VN00000 JCADR0CMS00.0 ITP 61
Related products and manuals for Musical Instruments Yamaha QR10
Musical Instruments Yamaha 860 User Manual
(18 pages)
(18 pages)
(92 pages)
Musical Instruments Yamaha TG77 User Manual
(19 pages)
(19 pages)
Musical Instruments Yamaha AN1x User Manual
(20 pages)
(20 pages)
Musical Instruments Yamaha SU10 User Manual
(89 pages)
(89 pages)
Musical Instruments Yamaha PSR-3000 User Manual
(217 pages)
Musical Instruments Yamaha ES User Manual
(10 pages)
(10 pages)
(8 pages)© 2020, manymanuals.com. All rights reserved. | 0.170 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals