Yamaha WR250F(W) Service Manual download pdf (Page 51)

2-26

CABLE ROUTING DIAGRAM

C. Pass the starter motor lead

through the hole in the relay

holder.

D. Fit the cover securely.

E. Connect the wire harness to the

starter relay.

F. Fasten the catch tank breather

hose and catch tank hose to the

rear frame. Clamp them close to

where they are joined to the

frame. Fasten the pipe tightly

enough not to crush it. Locate

the clamp end facing toward the

rear of the frame with the tie end

facing downward.

G. Fasten the (three) CDI unit leads

and taillight lead to the rear

frame. Locate the clamp end

facing toward the upper side of

the frame and cut off the tie end.

H. Connect the negative battery

lead to the battery negative ter-

minal.

I. Connect the negative battery

lead to the wire harness.

J. Fasten the wire harness to the

rear frame. Locate the clamp

end facing toward the upper side

of the frame and the tie end to-

ward the inside of the frame.

Clamp the wire harness at the

marking.

K. Pass the wire harness, starter

relay lead, starting circuit cut-off

relay lead and negative battery

lead through the hole in the relay

holder.

L. Fasten the (three) CDI unit leads

and taillight lead to the rear

frame. Locate the clamp end

facing toward the lower side of

the frame and cut off the tie end.

M. Fasten the taillight lead to the

rear frame. Locate the clamp

end facing toward the upper side

of the frame and cut off the tie

end.

N. Do not allow the taillight lead to

slacken.

O. Locate the CDI unit lead be-

tween the CDI unit and rear

fender.

P. Locate the CDI unit coupler in

the clearance between the up-

per side of the CDI unit and low-

er side of the catch tank stay.

Q. Locate the CDI unit lead be-

tween the CDI unit and rear

frame.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 221 222

Comments to this Manuals

No comments