Yamaha MDX-596 Owner's Manual download pdf (Page 13)

E-13

English

5 Press #/* (PLAY # on the remote) to start

recording.

The TOC indicator lights up.

When the TOC indicator is lit, this means that the TOC

information has not yet been written to the disc. After

recording is complete, the TOC data is automatically

written to the disc.

6 Start playing the program source to be

recorded.

To pause

Press #/* (PAUSE * on the remote).

Press again to resume recording.

To stop

Press & (STOP & on the remote).

To eject the MD

Press ) EJECT.

Should not light

Adjusting Recording Levels

Setting the digital volume level

The volume level of digital audio sources is often

similar, however, level differences may be quite obvious

between different digital audio formats and even

between one recording and another. To maintain a

consistent volume level in MD recordings, it is possible

to change the volume of the input digital signal.

To select the digital signal to be recorded or monitored,

press INPUT repeatedly until the appropriate digital

input indicator (DIGITAL OPT. 1 or DIGITAL OPT. 2)

appears in the display. During record or record pause

mode, turning DIGITAL REC LEVEL adjusts the

volume of the digital signal. The digital volume can be

adjusted up to +12 dB and down to a minimum (MIN)

level from the default volume of 0 dB, the level of the

input digital signal. To set the volume level, play the

digital source to be recorded and adjust DIGITAL REC

LEVEL so that the highest peak causes the 0 dB level

indicators to flicker. The OVER indicators should not

light.

Even when recording is stopped, the digital recording

level is maintained in memory.

Notes

• When DIGITAL REC LEVEL is turned, the digital

volume level is adjusted in 0.5 dB steps between +12 dB

and –20 dB, 1 dB steps from –20 dB to –30 dB, 2 dB steps

from –30 dB to –40 dB, followed by –44 dB, –48 dB,

–54 dB, –62 dB and MIN.

• Although some sources can be recorded with lower peak

levels, setting the peak levels too low may degrade the

quality of the recording.

• The digital volume cannot be adjusted while a track title is

being entered.

• The digital recording levels are maintained independently

for DIGITAL OPT. 1 and DIGITAL OPT. 2.

Setting the analog recording level

Press INPUT repeatedly until the ANALOG indicator

appears in the display, and press REC (REC ‡ on the

remote) to put this unit in the record pause or monitor

out mode. For best results, play the loudest passage of

the source to be recorded and watch the recording level

meter in the display. Adjust ANALOG REC LEVEL so

that the highest peak causes the 0 dB level indicators to

flicker. The OVER segment should not light.

–

60 30 10 6 4 2 1 0 OVER00

––– – ––

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 183 184

Comments to this Manuals

No comments

Yamaha MDX-596 Owner's Manual Page 13

Comments to this Manuals