Yamaha YDRA Operator's Manual download pdf (Page 18)

MAINTENANCE

1

2

3

4

5

6

7

8

9

10

11

8-7

JW1

Y-60

B

A

Y-508

Inspection and cleaning:

3. Wash the foam pre-filter in soap

and water. Allow it to dry.

å Soap and water

∫ Foam element

4. Check the filter element. If

damaged or dirty, replace it.

Do not wring out the foam

pre-filter, this could cause it to

tear.

5. To replace the elements,

reverse the above steps.

The pre-filter has a notch on one

side. It will only fit in the case one

way. Serious engine damage can

result from an improperly posi-

tioned filter.

Drive Belt

To remove the drive belt:

1. Set the drive select lever halfway

between forward and reverse.

2. Pull up on the drive belt and

push it outward over the edge of

the secondary sheave.

3. Turn the secondary sheave

clockwise and the drive belt will

roll off the sheave.

4. Remove the drive belt from the

primary sheave.

NOTICE

NOTICE

LIT_19626_11_09:LIT_19626_16_05.qxd 5/19/09 9:34 AM Page 34

1

2

3

4

5

6

7

8

9

10

11

4-3

JW1

SAFETY PRECAUTIONS

DURING MAINTENANCE

When performing maintenance, follow

all safety instructions contained in the

manufacturer’s operation and service

manuals, as well as the following

safety procedures:

l

Properly immobilize golf car before

beginning any maintenance to avoid

any unexpected vehicle movement.

l

Properly block chassis before

working underneath golf car to avoid

any unexpected vehicle movement.

l

Before disconnecting any part of the

fuel system, drain the applicable part

of the system to prevent fuel leaks.

l

When working on the fuel system or

the battery, do not smoke, or allow

any sparks or open flames near

the vehicle, to avoid any fires or

explosions.

l

Before performing any maintenance,

disable the car’s electrical system in

accordance with the manufacturer’s

instructions.

l

Use only properly insulated tools

when working on electrically

powered golf cars or around

batteries to avoid electrical shock or

damage to the electrical system.

l

Maintain all safety devices, includ-

ing brakes, steering mechanisms,

warning devices and governors, in a

safe operating condition. Do not

modify these safety devices as

supplied by the manufacturer.

l

After each maintenance or repair,

the car must be driven by a

qualified, trained and authorized

person – in an area free of

pedestrian traffic – to ensure proper

operation and adjustment.

l

Record all maintenance performed

in a maintenance record log by

date, name of person performing

maintenance and type of

maintenance. Periodically inspect

maintenance log to ensure

accurate and complete entries.

l

Provide operator comment cards

to assist in identifying non-periodic

maintenance needs for specific

golf cars.

l

Maintain in a legible condition all

nameplates, warnings, and

instructions provided by the

manufacturer.

l

If new nameplates, warnings or

instructions are needed, contact

your Yamaha Golf-Car Company

dealer.

FUEL HANDLING/

STORAGE AND

BATTERY CHARGING

Take the following precautions to

ensure maintenance worker safety:

l

Supervise the storage and

handling of liquid fuels in

accordance with applicable fire

and safety requirements to avoid

any fires or explosions.

l

Only use battery charging facilities

and procedures that are in

accordance with applicable

ordinances and regulations to

avoid explosions, electrical shock

or damage to the electrical system.

l

Periodically inspect fueling to be

certain that applicable safety

codes, regulations and

procedures are being followed to

avoid any fires or explosions.

SAFETY CONSIDERATIONS

!

LIT_19626_11_09:LIT_19626_16_05.qxd 5/19/09 9:34 AM Page 15

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Comments to this Manuals

No comments