Yamaha Tyros4 Owner's Manual download pdf (Page 22)

22 Tyros4 Reference Manual

6 Set the parameters for the assigned Wave in the Add Wave dis-

play.

From this display, you can set a number of parameters related to how the sound

will be mapped to the keyboard.

7 Press the [H] (EXECUTE) button to actually assign the Wave.

Completion of the Assign operation will return to the Key Mapping display.

8 If you want to assign another Wave to this Element, repeat

steps 5–7.

[1 ] FIXED PITCH When this is set to ON, all keys will play the Wave sound at the same pitch. When set

to OFF, the pitch of the Wave sound changes according to the key played, based

around the original pitch (set at Center Key below).

[2 ]/

[3 ]

CENTER KEY This determines the key to which the original pitch of the sound is assigned. When

Fixed Pitch (above) is set to OFF, keys below the Center Key play the sound progres-

sively lower in pitch, while keys above play the sound progressively higher. Normally,

you’ll want to make sure that this is the same as the original sound; for example, if the

original pitch of the audio was at C3, set Center Key to C3 for best results. When

Fixed Pitch (above) is set to ON, this has no effect. You can specify this setting

directly from the keyboard by simultaneously holding down the [2 ] (DIRECT

KEY) button and pressing the desired key on the keyboard.

[4 ]/

[5 ]

START KEY This determines the lowest key at which the Wave will sound. Use this with End Key

(see step 9 on page 23) to set the key range for the Wave. You can specify this setting

directly from the keyboard by simultaneously holding down the [4 ] (DIRECT

KEY) button and pressing the desired key on the keyboard.

[6 ] WAVE VOLUME This determines the playback volume for the specific Wave. Normally, this should be

set to the maximum (127); however, you can use it to adjust the level balance among

multiple sounds in the Element.

If you want to store the Voice at this

point, press the [J] (STORE) button. The

Custom Voice display will appear. Refer

to step 12 on page 23 about the Custom

Voice display. Each time you make

some change (e.g., add a Wave to the

Element or add an Element to the

Voice), you should store the Voice.

NOTE

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 140 141

Comments to this Manuals

Jaro Kolar 13 Jan 2025 | 11:18:39

Mate manual na yamaha tyros 4 v českom alebo slovenskom jazyku?prosim velmi dakujem

Jiří Ondra 26 Mar 2025 | 06:37:39

Prosim o Český manual na muj Tyros 4

Yamaha Tyros4 Owner's Manual Page 22

Comments to this Manuals

Related products and manuals for Digital pianos Yamaha Tyros4