Yamaha TSX-10 Owner's Manual download pdf (Page 26)

ADDITIONAL INFORMATION

Troubleshooting

If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the

simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the

power cord and contact your authorized YAMAHA dealer or service center for help.

The main unit does not switch ON

when STANDBY/ON is pressed.

No sound from one speaker.

The sound suddenly disappers.

No sound from an external

component connected with the main

unit or play does not begin.

Sound distorted.

Cannot set timer.

The main unit does not work

normally.

Excessive static in FM broadcasts.

Noise increases during stereo

broadcast reception.

Stereo broadcasts are noisy and the

STEREO indicator blinks on and off.

Cannot select preset stations.

Buzzing or static during AM

broadcasts.

AM broadcast sensitivity is poor.

SYMPTOM CAUSE REMEDY

Securely connect the power cord.

Connect properly.

Check the speaker wires are not touching each other

and then turn the main unit back on.

Connect the cords properly. If the problem persists,

the cords may be defective.

Select AUX by pressing the INPUT button.

Turn on the component.

Set current time.

Unplug the AC power cord from the wall outlet, and

then plug in again after about one minute.

Position the FM antenna as high and as far away

from nearby roads as possible. Connect using a

coaxial cable.

Check the antenna connection.

Install a multi-element type FM antenna if possible.

Install an antenna appropriate for the electric field

strength of your area.

Reprogram memory presets.

The problem is difficult to eliminate, but can be

lessened by grounding the AM loop antenna.

Move away from the TV or microprocessor.

Properly connect the AM loop antenna.

Change orientation of the AM loop antenna.

Install an external AM loop antenna.

The AC power cord is not connected or not

completely connected.

Loose speaker connections.

The protection circuit has been activated

because of a short circuit, etc.

Incorrect cord connections.

Input source selection is not proper.

The external component connected to the

LINE IN terminal of the main unit is not

turned on.

Current time is not set.

The internal microcomputer has been frozen

by an external electric shock (lightning,

excessive static electricity, etc.) or the power

supply voltage is too low.

Interference from the starting motor of a

nearby car.

Interference from the thermostat of a nearby

electrical appliance.

Antenna input is too weak due to obstructions

or excessive distance from the broadcasting

station.

Insufficient antenna input.

Preset memory has been erased.

Interference from sources such as lightning,

fluorescent lights, electric motors or the

thermostat of nearby electrical appliance.

A TV or microprocessor is being used

nearby.

Radio signal is weak or the antenna is not

properly connected.

GENERAL

TUNER

10/TSX-10E(6.12)b 01.6.12, 4:18 PM24

1 2 ... 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Yamaha TSX-10 Owner's Manual Page 26

Comments to this Manuals

Related products and manuals for CD players Yamaha TSX-10