Yamaha RX-V781 Owner's Manual download pdf (Page 24)

En 24

⬛ Connecting speakers

Connect the speakers placed in your room to the unit.

Precaution for connecting of the speaker cables

Improper connecting of the speaker cables may cause short circuit and also damage the unit

or the speakers.

• Remove the unit’s power cable from an AC wall outlet and turn off the subwoofer before

connecting the speakers.

• Twist the bare wires of the speaker cables firmly together.

• Do not let the bare wires of the speaker cable touch one another.

• Do not let the bare wires of the speaker cable come into contact with the unit’s metal parts

(rear panel and screws).

If “Check SP Wires” appear on the front display when the unit is turned on, turn off the unit, and

then check the speaker cables short circuit.

Speakers to be connected

If you have nine speakers, you can use the both surround back speakers and front presence

speakers. In this case, the unit automatically changes the speakers to be used, depending on

the input signal and CINEMA DSP.

If you have seven speakers, use two of them as surround back speakers (*1) or front presence

speakers (*2).

If you have five speakers, use two of them as surround speakers (*3) or front presence speakers

(*4).

• You can also connect up to 2 subwoofers (with built-in amplifier) to the unit.

• When apply this speaker configuration, set “Power Amp Assign” (p.111) to “Basic” (default).

Cables required for connection (commercially available)

Speaker cables (the number of speakers)

Audio pin cable (two for connecting two subwoofers)

Speaker type

Speaker system

(the number of channels)

7.1/5.1.2 5.1 2.1

Front (L/R) 12 ⚫⚫⚫

Center 3 ⚫⚫

Surround (L/R) 45 ⚫⚪*3

Surround back (L/R) 67 ⚪*1

Front presence (L/R) ER ⚪*2 ⚪*4

Subwoofer 9 ⚫⚫⚫

–

1 ... 23 24 25 ... 155

No comments

Yamaha RX-V781 Owner's Manual Page 24