Yamaha RP-U100 Manual download pdf (Page 56)

Opening Page 27/68 ページ

Volume

Power Status

STANDBY

AC power cord is connected and unit power switch or Application

power button was set to STANDBY.

AC power cord is connected and unit power switch or Application

power button was set to ON.

Main Panel (Standby) details

Main Panel (On) details

Power Off

OFF AC power cord is disconnected.

Volume Control

Volume control

Drag the volume indicator dot around the circumference of the DSP

button.

When the volume indicator is selected, the green dot becomes

red.

To increase the volume, drag the dot clockwise. To decrease the

volume, drag the dot counterclockwise.

Using the Setup Dialog, you can set the upper volume limit for the volume as

adjusted with the application. This helps to prevent excessively loud settings made by

mistake.

If the volume control on the RP-U100 main unit was used to set the volume to a

level higher than the upper limit for the application, the volume will return to the

upper limit setting the next time the volume control of the application is used.

Note that the volume may sometimes jump up suddenly when the dot on the

application is moved. You should therefore pay attention to the MAX VOLUME

POSITION on the setup dialog.

Setup Dialog details

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 96 97

No comments

Yamaha RP-U100 Manual Page 56