Yamaha QL5 Owner's Manual download pdf (Page 21)

Input and output patching

Reference Manual

Directly outputting an INPUT channel

The signal of an INPUT channel can be output directly from an OUTPUT jack on the I/O

device, from the desired OMNI OUT jack, or from the output channel of a desired slot.

NOTE

If you install a digital I/O card in a slot and digitally connect an external device, you must

synchronize the word clock of the QL console and the external device (page 184).

INSERT/DIRECT OUT window (1ch)

1 DIRECT OUT field

Enables you to make settings for direct output. Press one of four fields to choose PRE HPF

(immediately before the HPF), PRE EQ (immediately before the EQ) or PRE FADER

(immediately before the fader), or POST ON (immediately after the [ON] key) as the direct

output position.

2 DIRECT OUT PATCH button

Displays the currently-selected Direct Out output port. Press this button to open the

PORT SELECT window, in which you can select an output port.

3 DIRECT OUT ON button

Switches the Direct Out on or off.

4 DIRECT OUT LEVEL knob

Indicates the output level of the Direct Out. You can use the [TOUCH AND TURN] knob

to adjust the level.

5 APPLY TO ALL INPUT button (input channels only)

Specifies whether the insert point/Direct Out point settings will be applied to all input

channels.

6 Close button

Closes the screen.

STEP

1. Use the Bank Select keys in the Fader Bank section and the [SEL] keys on the top

panel to select the INPUT channel that you want to output directly.

2. Press the popup button in the INSERT field in the SELECTED CHANNEL VIEW screen.

3. Press the DIRECT OUT PATCH button in the INSERT/DIRECT OUT window.

4. Select an output port.

5. Press the DIRECT OUT ON button.

SELECTED CHANNEL VIEW screen INSERT/DIRECT OUT window (1ch)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 263 264

No comments

Yamaha QL5 Owner's Manual Page 21