Yamaha BEARTRACKER YFM250XN Owner's Manual download pdf (Page 53)

6-3

TE:

● If the engine fails to start, release the

start switch, then push the start switch

again. Pause a few seconds before the

next attempt. Each cranking should be

as short as possible to preserve bat-

tery energy. Do not crank the engine

more than 10 seconds on each at-

tempt.

● If the battery is discharged, pull the re-

coil starter to start the engine.

7. If the engine is started at position 1,

the starter (choke) should be returned

to position 2 (half-open) to warm up

the engine. If the engine is started at

position 2, keep it at this position to

warm up the engine.

8. Continue warming up the engine until

it idles smoothly and return the starter

(choke) to position 3 (closed) before

riding.

CAUTION:

See the “Engine break-in” section prior to

operating engine for the first time.

EBU00180

Starting a warm engine

To start a warm engine, refer to the “Start-

ing a cold engine” section. The starter

(choke) should not be used. The throttle

should be opened slightly.

EBU00182

Warming up

To get maximum engine life, always warm

up the engine before starting off. Never ac-

celerate hard with a cold engine! To see

whether or not the engine is warm, check if

it responds to the throttle normally with

the starter (choke) turned off.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 155 156

No comments

Yamaha BEARTRACKER YFM250XN Owner's Manual Page 53