QL5/QL1 Firmware Update Guide 16
Disable all but one of the network interfaces on your computer.
You should also disable the wireless LAN.
Select [Start]→[All programs]→[Audinate]→[Dante Firmware Update Manager]→[Dante Firmware
Update Manager ] , then right-click and select “Run as Administrator.”
The Dante Firmware Update Manager will start up.
・ The "User Account Control" dialog box may appear. Click [Continue] or [Yes].
If you see the interface selection screen, select the interface card to connect the Dante device.
8.
Click [Failsafe Recovery].
When the QL is detected, click the [Stop Scan] button.
If several minutes have passed without detection, use Dante Controller to check whether the cable might be
disconnected or broken, whether the TCP/IP settings are correct, and whether the QL is running.
Select the check box of the detected QL.
A pop-up is displayed confirming that you wish to proceed.
Click [OK] to start the recovery.
Firmware Update Manager will display "Processing Safe Recovery", and then "Safe recovery Done" when the
device(s) are recovered.
Comments to this Manuals