Yamaha A-S1000 Owner's Manual download pdf (Page 17)

17 En

■ Bi-wire connection

The bi-wire connection separates the woofer from the

combined midrange and tweeter section. A bi-wire

compatible speaker has four binding post terminals. These

two sets of terminals allow the speaker to be split into two

independent sections. With these connections, the mid and

high frequency drivers are connected to one set of

terminals and the low frequency driver to another set of

terminals.

When making bi-wiring connections, use speakers with an

impedance of 4 Ω or higher.

When making bi-wiring connections, remove the shorting bridges

or cables on the speaker.

To use the bi-wire connections, switch the SPEAKERS selector

to the A+B BI-WIRING position.

■ VOLTAGE SELECTOR

(Asia and General models only)

The VOLTAGE SELECTOR on the rear panel of this unit

must be set for your local voltage BEFORE plugging the

power cable into the AC wall outlet. Improper setting of

the VOLTAGE SELECTOR may cause damage to this

unit and create a potential fire hazard.

Rotate the VOLTAGE SELECTOR clockwise or

counterclockwise to the correct position using a straight

slot screwdriver.

Voltages are as follows:

........................ AC 110/120/220/230–240 V, 50/60 Hz

■ Connecting the power cable

Connect the power cable into the AC IN inlet on the rear

panel when all connections are complete, and then plug in

the power cable to the AC wall outlet.

Caution

Note

SPEAKERS L CH

Caution

230-

240V

VOLTAGE SELECTOR

Voltage

indication

English

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

No comments

Yamaha A-S1000 Owner's Manual Page 17