Yamaha BRX-610 User Manual download pdf (Page 14)

CONNECTION

12 En

■ Connecting speaker cables

Each speaker has two speaker cables. One is for

connecting the – (negative) terminal of the unit and the

speaker, and the other is for the + (positive) terminal. The

cables are different colors, so they do not get mixed up.

Connect the black side to the – (negative) terminal and the

other side to the + (positive) terminal.

1 Remove approximately 10 mm of insulation from the

end of the speaker cable and twist the bare wire

firmly.

2 Press the tab on the speaker terminal down.

3 Insert the bare wire of the speaker cable into the

terminal.

4 Lift the tab to secure the speaker cable.

■ Connecting an active subwoofer

When connecting an active subwoofer (built-in amplifier),

use a monaural pin cable. Before connecting an active

subwoofer, turn it off.

About subwoofer speaker

• Use the speaker terminal to connect a passive

subwoofer speaker. Use the SUBWOOFER output jack

to connect an active subwoofer speaker (built-in

amplifier).

• You can adjust the subwoofer volume level by using

this unit’s remote control. For an active subwoofer

speaker (built-in amplifier), you can also use the control

on the subwoofer to adjust volume level. Use these

functions to decrease the volume level if strange noise

or sound is output from the subwoofer.

• If you are not using a subwoofer speaker, select SETUP

menu = [Audio Setting] = [Speaker Setting] =

[Configuration] = [SW] = [Disable].

You can enjoy listening to FM radio stations by

connecting the supplied indoor FM antenna.

If there is a problem of weak radio wave reception in your area or

you want to improve radio reception, we recommend that you use

commercially available outdoor antennas. For details, consult the

nearest authorized Yamaha dealer or service center.

You can enjoy music stored in your iPod by connecting it

to this unit.

This unit is compatible with iPod classic, iPod nano (2nd, 3rd,

4th, 5th and 6th generation), iPod touch (1st, 2nd, 3rd, and 4th

generation), iPhone, iPhone 3G/3GS, and iPhone 4.

• Make sure the USB cable is connected securely between

your iPod and this unit.

• Connect your iPod to the front USB port of this unit. The

rear USB port is not compatible with your iPod.

Monaural pin cable

Connecting the FM antenna

Note

Connecting iPod

Note

Notes

USB PORTABLE

iPod/iPhone

USB port

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 224 225

Comments to this Manuals

No comments

Yamaha BRX-610 User Manual Page 14

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Yamaha BRX-610