Yamaha PDM-4210 Manual download pdf (Page 11)

SAFETY INSTRUCTIONS(continued)

• FCC (Federal Communications Commission) STATEMENT WARNING

(DECLARATION OF CONFORMITY PROCEDURE)

Responsible Party: Yamaha Electronics Corporation

Address: 6660 Orangethorpe Avenue

Buena Park, CA90620

Telephone: 714-522-9105

Fax: 714-670-0108

Type of Equipment: High Definition Plasma Monitor

Model Name: PDM-4210

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following conditions:

1) this device may not cause harmful interference, and

2) this device must accept any interference received including interference that may cause undesired operation.

See the user manual instructions if interference to radio reception is suspected.

1. IMPORTANT NOTICE: DO NOT MODIFY THIS

UNIT!

This product, when installed as indicated in the instructions

contained in this manual, meets FCC requirements.

Modifications not expressly approved by Yamaha may void your

authority, granted by the FCC, to use the product.

2. IMPORTANT:

When connecting this product to accessories

and/or another product use only high quality shielded cables.

Cable/s supplied with this product MUST be used. Follow all

installation instructions. Failure to follow instructions could void

your FCC authorization to use this product in the USA.

3. NOTE:

This product has been tested and found to comply with

the requirements listed in FCC Regulations, Part 15 for Class

“B” digital devices. Compliance with these requirements

provides a reasonable level of assurance that your use of this

product in a residential environment will not result in harmful

interference with other electronic devices.

This equipment generates/uses radio frequencies and, if not installed

and used according to the instructions found in the users manual, may

cause interference harmful to the operation of other electronic devices.

Compliance with FCC regulations does not guarantee that interference

will not occur in all installations. If this product is found to be the

source of interference, which can be determined by turning the unit

“OFF” and “ON”, please try to eliminate the problem by using one of

the following measures:

Relocate either this product or the device that is being affected by the

interference.

Utilize power outlets that are on different branch (circuit breaker or

fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If

the antenna lead-in is 300 ohm ribbon lead, change the lead-in to

coaxial type cable.

If these corrective measures do not produce satisfactory results, please

contact the local retailer authorized to distribute this type of product. If

you can not locate the appropriate retailer, please contact Yamaha

Electronics Corp., U.S.A. 6660 Orangethorpe Ave, Buena Park, CA

90620.

The above statements apply ONLY to those products distributed by

Yamaha Corporation of America or its subsidiaries.

FCC INFORMATION (for US customers only)

COMPLIANCE INFORMATION STATEMENT

Cleaning the surface of the cabinet

When stained, soak a soft cloth in a mild detergent diluted with water, wring and wipe, and then finish with a dry cloth.

Do not use chemical dustcloths, cleaners, waxes, or acidic/ alkali detergents as these may cause deformations or cracks in the

cabinet.

01_PDM-4210_U_En 2003.11.28 17:12 ページ 10

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 45 46

Comments to this Manuals

No comments

Yamaha PDM-4210 Manual Page 11

Comments to this Manuals