Yamaha PDM-4210 Manual download pdf (Page 17)

OPERATING INSTRUCTIONS

Turning Power On and Off

•

To turn the monitor power on, press the main power

switch on the monitor main unit to ON, and then press

the SUB POWER button or the ON/OFF or ON button on

the remote control.

•

To turn the monitor power off, press the SUB POWER

button or the ON/OFF or OFF button on the remote

control, and then set the main power switch on the

monitor main unit to OFF.

• During normal use, the main power switch is set in the ON

position, and the monitor can then be turned ON/OFF using the

SUB POWER button or the ON/OFF button on the remote control.

Indicating lamp

Indicating

lamp

Power status Operating

Off Off

When the main power switch is set

to OFF.

Lights red

Off

(standby)

When the main power switch is

ON, and the OFF button on the

remote control or the SUB POWER

button on the underside of the

front of the frame is OFF.

Lights green On

When the main power switch is

ON, and the ON button on the

remote control or the SUB POWER

button on the underside of the

front of the frame is ON.

Lights orange

Off

(Power Save)

When the main power switch is

ON, and the ON button on the

remote control or the SUB POWER

button on the underside of the

front of the frame is ON.

However, the indicator also light orange

when the unit is in POWER SAVE mode.

When the indicating lamp lights orange or the message “No Sync.

Signal”, “Power Save” or “Invalid Scan Freq.” appears on the screen,

see “Power Save Mode” or “Symptoms That Appear to be Failures.”

AV1 AV 2

RGB 1 RGB 2

AV3

MUTE VOL

VOL

AV4

AUTO PinP

SIZE RECALL

ID SET

POWER OFF

button

POWER ON

button

POWER ON/OFF

button

SUB-POWER button

Main power switch

Indicating lamp

ATTENTION

• Avoid repeatedly turning the monitor on and off at short intervals.

Failures might result from such operation.

• Turn off the main power switch if you do not plan to use the

monitor for an extended period of time.

• If a power failure occurs while the main unit is running, it will be

powered on upon recovery from the failure. Turn off the unit main

power switch before you leave the area in which the main unit is

located.

01_PDM-4210_U_En 2003.11.28 17:12 ページ 16

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Comments to this Manuals

No comments

Yamaha PDM-4210 Manual Page 17

Comments to this Manuals