Yamaha PSR-2700 Owner's Manual download pdf (Page 66)

| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |

PSR-2700 Digital Sampling

XPlay the Source and Adjust the Level ..................................................................................................

Play the sound you intend to record, via microphone or line, and adjust

the INPUT LEVEL control while watching the level indicators above the

control. The length of the “bar” formed by the level indicators increases as

input level increases. For optimum sound quality, your input signal should

cause most of the indicators to light, but not all. If all indicators including

the red “0 dB” indicator light in response to the input signal you’re prob-

ably overloading the input circuitry and will end up with distorted sound. At

the other extreme, if none of the indicators light, or only the lowest one or

two indicators light, then the input signal is too small and the level of the

recorded sound will be too low.

NOTES

• The keyboard and other function buttons will not operate in the level

check mode.

■Setting the Sampling Frequency

The length of the sample you can record and its sound quality are determined by the “sampling frequency”. A

high sampling frequency produce better sound quality but shorter samples; a low sampling frequency allow

longer recording but with reduced sound quality. The PSR-2700 gives you two sampling frequency settings:

ZPress the [FREQ] Button .......................................................................................................................

Press the DIGITAL SAMPLING section [FREQ] button. The current

sampling frequency setting will appear on the LCD display panel.

XSelect a Frequency Setting ...................................................................................................................

Use the [+] and [–] buttons, the number buttons, the data dial, or the

[FREQ] button itself to select the desired sampling frequency setting

(“LOW” or “HIGH”).

NOTES

• The “LOW” setting is automatically selected when the PSR-2700

power is initially turned on.

08:Showtune 001:GrandPno

AccOff Frequency=1–:LOW



INPUT LEVEL

MIN MAX

0 dB

–

6

–

12

–

18

–

24

–

30

–

FREQ

021

–+

RESET

Setting Length Sound Quality

1: LOW 6 sec. (approx.) Low

2: HIGH 3 sec. (approx.) High

CExit...........................................................................................................................................................

Once the input level has been set properly, press the DIGITAL SAM-

PLING [REC] button to exit from the level check mode.

REC