Yamaha PLG150-AN Owner's Manual download pdf (Page 50)

Parameters / Setup Detail Parameter Window

• Key On Reset

Settings:

Off: LFO 1 and LFO 2 do not reset, but modulate continuously.

On: LFO 1 and LFO 2 reset every time a key is pressed.

This determines the start point of the LFO 1 and LFO 2 cycle.

• Sync Pmod Sw.

Settings: Master, Slave, Both

The Sync Pitch Modulation Switch setting determines which oscillator (master, slave, or

both) is modulated by the LFO 1 or LFO 2. Depth rate is determined by the LFO1/LFO2

VCO1 setting. This parameter is effective when the SYNC MODE is set to “VCO1 Master

> Slave.”

EQ Parameters

• Low Freq. (Low Frequency)

Range: 32 Hz ... 2.0 kHz

This determines the frequency which is boosted or cut with the EQ LO parameter in the

main control panel.

• High Freq. (High Frequency)

Range: 500 Hz ... 16.0 kHz

This determines the frequency which is boosted or cut with the EQ HI parameter in the

main control panel.

• Mid Freq. (Mid Frequency)

Range: 100 Hz ... 10.0 kHz

This determines the frequency which is boosted or cut with the EQ MID parameter in the

main control panel.

• Mid Resonance

Range: 1.0 ... 12.0

This determines the width of the frequency band which is boosted or cut with the EQ MID

parameter in the main panel. The central frequency is set with the Mid Frequency

parameter (above). Higher values result in a narrower band width.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 92 93

No comments

Yamaha PLG150-AN Owner's Manual Page 50