Yamaha PLG150-AN Owner's Manual download pdf (Page 49)

Parameters / Setup Detail Parameter Window

• LPF

Range: 1.0 kHz ... 18.0 kHz, Thru

This determines the frequency of the low pass ﬁlter that is applied to the distortion sound.

Depending on the Guitar Amp. Type setting, this parameter can be used to “fatten” the

sound or make it piercing and brittle. When this is set to “Thru,” no ﬁltering is applied to

the distortion sound.

• Output Level

Range: 0 ... 100

This determines the output volume of the distortion sound. Keep in mind that this may

not have any effect unless the Dry/Wet Balance is set to an appropriate value.

LFO Parameters

• Assign Group

Settings:

LFO1 (All)

LFO1 (VCO1, VCO2, VCA) - LFO2 (VCF)

LFO1 (VCO1, VCO2) - LFO2 (VCA, VCF)

LFO1 (VCO1) - LFO2 (VCO2, VCA, VCF)

LFO2 (All)

This determines the destination choices for the LFO 1 and LFO 2 modulation. When one

of the “(All)” settings is selected, all of the available destinations (VCO1, VCO2, VCA, and

VCF) are grouped to the selected LFO, 1 or 2. The LFO blocks in the main panel control

automatically change when this parameter is set. The basic parameters of Wave and

Speed (as well as the Detail page) remain intact for both LFOs, no matter what setting is

made here.

• LFO 1 Delay

Range: 0 ... 127

The LFO 1 Delay setting determines the delay time of the modulation. Lower values

result in shorter LFO 1 Delay times, and higher values result in longer Delay times.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 92 93

No comments

Yamaha PLG150-AN Owner's Manual Page 49