Yamaha N-100 Owner's Manual download pdf (Page 28)

Keyboard Stand Assembly

N-100 Owner’s Manual

ENGLISH

2-3While supporting B with your hand, pass the

pedal cord (attached to C) through from the

inside to the outside of B.

Position C upside down, then insert it into the

slot on B. Be sure to push C until it stops.

2-4While holding and pressing C securely into the

slot, ﬁx it to B using four long screws (6x20mm).

2-5Turn B so that its bottom side of (the side on

which C is attached) is on the ﬂoor.

2-6Pass the pedal cord and power cord into the

groove on B, then attach them to the top of B

using the four vinyl ties.

Be sure to have the end of the power cord extend

past the top edge of B by 20cm or more (roughly

half the length of B).

2-7Replace the plastic cover onto the groove of B.

Do not insert the feet of the groove cover between

the groove socket and groove wall.

3. Fix B to A.

3-1Place B in front of A, with the speaker net on B

facing upward.

3-2Insert the speaker cord plug into the connector on

the bottom surface of A, with the plug’s tab facing

to the rear.

At least 20cm

20cm

Correct

Incorrect

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 41 42

No comments

Yamaha N-100 Owner's Manual Page 28