Yamaha DTX400K Owner's Manual download pdf (Page 11)

Setup

DTX400K/DTX430K/DTX450K Owner’s Manual

Assembly Guide

Preparing the base

supports

1. Take the two base supports (q) and the tuning key (!7)

from the package, and using the tuning key, securely

tighten the s key bolts (i.e., the key bolts labeled s in

the figure).

2. Using the tuning key, loosen the  key bolt on each of

the two base supports (q).

3. Viewing from the front as shown in the figure, place the

base supports (q) at the left and right approximately 50

cm apart.

Attaching the verti-

cal supports

1. Take a vertical support (w) from the package, and

insert it fully into the joint on the left base support.

2. Using the tuning key, tighten the  key bolt that you

loosened in in order to secure the vertical sup-

port (w) in place.

3. Repeat 1. and 2. to assemble the right upright bar.

Fully assembled drum kit

(DTX450K shown)

CAUTION

• Choose a flat, hard surface on

which to assemble your elec-

tronic drum kit.

• Take care to avoid mixing up

parts or assembling them in the

wrong direction. In addition, the

assembly steps should be com-

pleted one at a time in the order

described.

• The assistance of at least one

other person will be required

when assembling the electronic

drum kit.

• Once a piece has been assem-

bled, be sure to tighten the cor-

responding nuts or bolts.

• To disassemble your electronic

drum kit, carry out the assembly

sequence in reverse.

Step 5

Step 10

Step 8

Step 4

Step 7

Step 6

Step 11

Step 9

Step 3

Step 2

Step 1

The two base supports are identical.

Step 1

50 cm

Front

NOTE

The two vertical supports are identical.

CAUTION

After completing this step, lay the assembly down

safely to prevent it from falling over.

Step 2

Joint

Left

Right

NOTE

Step 1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 67 68

Comments to this Manuals

No comments

Yamaha DTX400K Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Music drums Yamaha DTX400K