PERIODIC MAINTENANCE AND ADJUSTMENT
7-14
7
Make sure that the O-ring is properly
seated.
9. Install the new oil filter cartridge
with an oil filter wrench, and then
tighten it to the specified torque
with a torque wrench.
10. Install the drain bolts and their new
gasket, and then tighten the drain
bolts to the specified torques.
11. Pour only 2.5 L (2.6 US qt,
2.2 Imp.qt) of the specified amount
of recommended engine oil
through the filler hole, insert the
dipstick, and then tighten the oil fill-
er cap.
12. Start the engine, rev it several
times, and then turn it off.
13. Remove the oil filler cap, and then
gradually fill the oil tank with the re-
maining oil quantity while regularly
checking the oil level on the dip-
stick.
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
ECA11620
● In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
1. O-ring 1. Oil filter cartridge
2. Torque wrench
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
Tightening torques:
Engine oil drain bolt (crankcase):
43 Nm (4.3 m·kgf, 31 ft·lbf)
Engine oil drain bolt (oil tank):
43 Nm (4.3 m·kgf, 31 ft·lbf)
Recommended engine oil:
See page 9-1.
Oil quantity:
Without oil filter cartridge replace-
ment:
3.70 L (3.91 US qt, 3.26 Imp.qt)
With oil filter cartridge replacement:
4.10 L (4.33 US qt, 3.61 Imp.qt)
U1BH13E0.book Page 14 Friday, June 1, 2012 3:25 PM
Comments to this Manuals