Yamaha 2013 Road Star Silverado S Owner's Manual download pdf (Page 37)

INSTRUMENT AND CONTROL FUNCTIONS

4-17

4

3. Tighten the locknut to the specified

torque. NOTICE: Always tighten

the locknut against the adjust-

ing nut, and then tighten the

locknut to the specified torque.

[ECA10121]

WARNING

EWA10221

This shock absorber assembly con-

tains highly pressurized nitrogen

gas. Read and understand the fol-

lowing information before handling

the shock absorber assembly.

● Do not tamper with or attempt to

open the cylinder assembly.

● Do not subject the shock ab-

sorber assembly to an open

flame or other high heat source.

This may cause the unit to ex-

plode due to excessive gas

pressure.

● Do not deform or damage the

cylinder in any way. Cylinder

damage will result in poor

damping performance.

● Do not dispose of a damaged or

worn-out shock absorber as-

sembly yourself. Take the shock

absorber assembly to a Yamaha

dealer for any service.

EAU15305

Sidestand

The sidestand is located on the left side

of the frame. Raise the sidestand or

lower it with your foot while holding the

vehicle upright.

TIP

The built-in sidestand switch is part of

the ignition circuit cut-off system, which

cuts the ignition in certain situations.

(See the following section for an expla-

nation of the ignition circuit cut-off sys-

tem.)

WARNING

EWA10241

The vehicle must not be ridden with

the sidestand down, or if the side-

stand cannot be properly moved up

(or does not stay up), otherwise the

sidestand could contact the ground

and distract the operator, resulting

in a possible loss of control.

Yamaha’s ignition circuit cut-off

system has been designed to assist

the operator in fulfilling the respon-

sibility of raising the sidestand be-

fore starting off. Therefore, check

1. Distance A

Spring preload:

Minimum (soft):

Distance A = 42.5 mm (1.67 in)

Standard:

XV17ASD(C)

Distance A = 42.5 mm (1.67 in)

XV17ATSD(C)

Distance A = 45.5 mm (1.79 in)

Maximum (hard):

Distance A = 51.5 mm (2.03 in)

Tightening torque:

Locknut:

35 Nm (3.5 m·kgf, 25 ft·lbf)

U1BH13E0.book Page 17 Friday, June 1, 2012 3:25 PM

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 107 108

Comments to this Manuals

No comments