Yamaha 2013 Road Star Silverado S Owner's Manual download pdf (Page 25)

INSTRUMENT AND CONTROL FUNCTIONS

4-5

4

from that point. In that case, push

the “ ” side of the “SELECT” switch to

switch the display between the various

tripmeter and odometer modes in the

following order:

F-TRIP → TRIP A → TRIP B → ODO

→ F-TRIP

TIP

Push the “ ” side of the “SELECT”

switch to switch the display in the re-

verse order.

To reset a tripmeter, select it by push-

ing the “ ” or “ ” side of the “SE-

LECT” switch, and then push the

“RESET” switch for at least one sec-

ond. If you do not reset the fuel reserve

tripmeter manually, it will reset itself au-

tomatically, and the display will return

to the prior mode after refueling and

traveling 5 km (3 mi).

Clock

The clock displays when the key is

turned to “ON”.

To set the clock

1. Turn the key to “ON”.

2. Push the “ ” side of the “SE-

LECT” switch and “RESET” switch

together for at least two seconds.

3. When the hour digits start flashing,

push the “ ” or “ ” side of the

“SELECT” switch to set the hours.

4. Push the “RESET” switch, and the

minute digits will start flashing.

5. Push the “ ” or “ ” side of the

“SELECT” switch to set the min-

utes.

6. Push the “RESET” switch and then

release it to start the clock.

Self-diagnosis device

This model is equipped with a self-diag-

nosis device for various electrical cir-

cuits.

If a problem is detected in any of those

circuits, the engine trouble warning light

will come on or flash and the display will

indicate an error code.

If the display indicates any error codes,

note the code number, and then have a

Yamaha dealer check the vehicle.

1. Clock

1

1. Error code display

2. Engine trouble warning light “ ”

1

2

U1BH13E0.book Page 5 Friday, June 1, 2012 3:25 PM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 107 108

Comments to this Manuals

No comments