Yamaha YVC-MIC1000EX User Manual download pdf (Page 29)

Select whether to output incoming sound through only the built-in speaker, only external speakers, or both the built-in

speaker and external speakers.

1 Hold down the volume + and - buttons ( ) for 2 seconds or more at the

same time.

The volume + and - buttons ( ) flash green.

The selected speaker is shown on the level indicator, and the voice guidance prompts you to determine the

speaker.

2 Press the volume + ( ) button or volume - ( ) button to change the required

speaker.

If the speaker is changed, the voice guidance notifies the user of information about the new speaker.

If the volume + ( ) button or volume - ( ) button is not pressed for 6 seconds or more, the product returns to

the normal mode.

Both the built-in speaker and external speakers cannot be disabled.

Selecting a speaker

Indicator pattern ( : ON, : OFF)

Speaker output

Sound is output only from the built-in speakers.

Sound is output from both the built-in speakers and external speakers.

Sound is output only from external speakers.

Operation Changed contents

Press the volume + button ( ). Switches whether to enable or disable the output of the built-in speaker.

Press the volume - button ( ). Switches whether to enable or disable the output of external speakers.

Level indicator

The table below shows indicator patterns viewed from this side.

Volume + and - buttons

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

No comments

Yamaha YVC-MIC1000EX User Manual Page 29