Yamaha Operations Owner's Manual download pdf (Page 147)

Chapter8—Patching

— Operation Guide 135

Patching to the recorder inputs

When the AW4416 is in the default state, buses 1–8 are assigned respectively to

recorder inputs 1–8 and 9–16, but you can assign the direct signals from the

input channels as desired.

Here’s how to assign the desired signals to recorder inputs 1–16.

1. Press the [SETUP] key → [F1] (Patch IN) key to access the SETUP screen

Patch IN page.

The RECORDER TRACK INPUT ASSIGN column will indicate the patched status

of recorder inputs 1–16.

Tip!

If the Patch IN tab is not assigned to the [F1] key, press the [SHIFT] key + [F1] key to

switch the tabs, and then press the [F1] key.

2. Move the cursor to the recorder input whose patching you wish to

change, and use the [DATA/JOG] dial to select the signal that you wish

to assign.

The following types of signal can be assigned to each input.

❍ Recorder inputs 1–16

Display Type of signal

BUS 1 – BUS 8 Buses 1–8

DIR 1 – DIR16 Input channel direct out 1–16

Buses 1–8

Mixer section Recorder section

Recorder

input patch

Tracks 1–8

Tracks 9–16

×8

RECORDER

TRACK INPUT

ASSIGN column

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 278 279

No comments

Yamaha Operations Owner's Manual Page 147