Yamaha DPX-1000 Owner's Manual download pdf (Page 16)

E-11

BASIC OPERATION

English

Basic Operations

This section describes the basic operation of the DXP-1000 once installation and connection have been completed. It is necessary to make

detailed settings in the menu described later so that the DXP-1000 is correctly set for the mounting, screen, input signals, and other condi-

tions of its installation. Follow the steps described in this section to carry out these procedures.

■ Turning on the power

Be sure to remove the lens cover before using this unit.

1. Plug the supplied power cord into the AC inlet on the

rear of the DXP-1000, then plug the cord into the wall

outlet. The STANDBY/ON indicator will turn orange.

2. Press the STANDBY/ON button (The button on

the remote control). The indicator will blink green and

the lamp inside the unit will light up, in preparation

for projection.

◆ Note ◆

• There are STANDBY/ON indicators located on the front panel

and the control panel of the main unit.

3. After approximately 35 seconds, the indicator will

stop blinking, indicating that preparations for projec-

tion are complete.

Important

• Be sure not to disconnect the power cord while the

power STANDBY/ON indicator is green, or blinking

green. This can cause significant damage to the

lamp and may result in a shorter lamp life or failure.

STANDBY/ON indicator

DVI

INPUT B

RGB/YP

/YC

D4 VIDEO G/Y B/P

R/P

INPUT A

HD/SYNC VD

OUT IN

REMOTE

RS-232C

S-VIDEO VIDEO

TRIGGER OUT

STANDBY

SETTING

LAMP COVER TEMP FAN

PATTERN

ESCAPE

INPUT

ASPECT

STANDBY/ON indicator

AC inlet

INPUT

PATTIRIS

AUTO

SETTING

ASPECT

ZOOM FOCUSV. POS

ESCAPE

STANDBY

SETTING

LAMP COVER TEMP FAN

PATTERN

ESCAPE

INPUT

ASPECT

STANDBY ON ( )

■ Turning off the power

1. Press the STANDBY/ON button when finished using

this unit.

There will be a message to confirm that you wish to turn the

unit off. Press the STANDBY/ON button once more to confirm

that you wish to do so. The lamp will switches to a half-lit

state, and the fan continues for roughly 2 minutes to cool the

lamp. During this time, the STANDBY/ON indicator blinks

orange. You cannot turn the unit on again by pressing the

STANDBY/ON button during this time.

◆ Note ◆

• The lamp may blink when in the half-lit state. This is not a

lamp failure.

2. Once cooling is completed, the STANDBY/ON

indicator will cease blinking, becoming a steady

orange.

Important

• Do not disconnect the power cord when the fan is

going and the STANDBY/ON indicator is blinking

orange. This could damage the lamp and result in

shorter lamp life or lamp failure.

3. Replace the lens cover and disconnect the unit from

the power outlet if you do not plan to use it for a long

time.

Important

• Condensation may appear on the unit if the

temperature of the surround environment changes

quickly. Condensation may also cause the

projected image to be cloudy. Switch off the unit

power until the condensation disappears.

Switching the unit on when condensation is

present may damage the unit.

Press again for standby.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 44 45

Comments to this Manuals

No comments

Yamaha DPX-1000 Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Data projectors Yamaha DPX-1000