Yamaha RX-V779 Owner's Manual Page 23

  • Download
  • Add to my manuals
  • Print
  • Page
    / 149
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 22
En 23
Push-type speaker terminals
(RX-V679 only)
a Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable, and twist the bare wires of
the cable firmly together.
b Press down the tab.
c Insert the bare wires of the cable into the hole in the
terminal.
d Release the tab.
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
Connecting front speakers that
support bi-amp connections
When using front speakers that support bi-amp
connections, connect them to the FRONT jacks and
SURROUND BACK/BI-AMP jacks.
To enable the bi-amp function, set “Power Amp Assign”
(p.104) in the “Setup” menu to “5ch BI-AMP” after
connecting the power cable to an AC wall outlet.
The FRONT jacks and SURROUND BACK/BI-AMP jacks output the
same signals.
Z
ONE 2/F.PRESENCE
EX
TRA SP
aa
b
c
d
+ (red)
- (black)
CENTER
FRONT
Audio pin cable
12
3
45
9
SURROUND CENTER
CLASS 2 WIRING CABLAGE CLASSE 2
FRONT
SINGLE
SURROUND BACK/BI-AMP
SPEAKERS
SUBWOOFER
ZONE2/F.PRESENCE
EXTRA SP
1
2
The unit (rear)
Caution
Before making bi-amp connections, remove any brackets or
cables that connect a woofer with a tweeter. Refer to the
instruction manual of the speakers for details. If you are not
making bi-amp connections, make sure that the brackets or
cables are connected before connecting the speaker cables.
Surround back speakers cannot be used during bi-amp
connections.
1 2 3 4 5 6 7 8 9 10 11
Page view 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 148 149

Comments to this Manuals

No comments