CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En 34
4
Connect the YPAO microphone to the YPAO
MIC jack on the front panel.
“Mic On. View ON SCREEN” appears on the front
panel display, and the following display appears on the
front panel display or TV screen.
5
Press kCursor B / C repeatedly to select
the “Measure” and press kENTER to start
measurement.
Auto measurement starts in 10 seconds.
Display during measurement
The following display appears when measurement
finishes without any problems.
k
Cursor B / C
kENTER
kRETURN
RETURN
ENTER
SCENE
L
ME
ENHANCE
UR. DE
DE
STRAIGHTSLEEP
URE DIRECT
OVI
USI
RADI
M
T
E
OP-U
EN
DI
PLAY
UR
E
AIN
Z
NE 2
RE
EIVE
CODE SE
NP
T
PTION
N
REE
NF
EM
RY
RESET
DMI
UDI
-
DOCK
PH
N
NER
TUNING
k
YPAO MIC
ZONE2 ZON
MAIN ZONE
VOL.
SW
C
LR
SL SR
SBL SBR
PR
PL
ENTER to Start
YPAO
VOL.
This completes preparation. To achieve more accurate
results, take note of the following when measuring
acoustics.
• It takes approximately 3 minutes to accurately
measure acoustics. Keep the room as quiet as possible
while acoustics are measured.
• Wait in a corner of the room, or leave it entirely, while
acoustics are measured to avoid creating an
obstruction between the speakers and the YPAO
microphone.
• To start the measurement immediately, press
kENTER again.
• To cancel the automatic setup and return to the
previous screen, press
kRETURN and then
kENTER.
VOL.
SW
C
LR
SL SR
SBL SBR
PR
PL
Progress
0%
YPAO
VOL.
VOL.
SW
C
L
SL SR
R
Save/Exit
YPAO
VOL.
Continues to the
next page
Comments to this Manuals