Yamaha RX-V667 Manual download pdf (Page 19)

CONNECTIONS

Connecting speakers

En 19

Check that “SP IMP.” is displayed on the front panel.

Press STRAIGHT repeatedly to select a “6ΩMIN.”

Switch this unit to the standby mode, and then

switch it on again.

The power turns on, when the settings you made has been

configured.

■

Connecting speakers

This type of jack can connect to the following speakers or

connection.

Remove approximately 10 mm of insulation from the

ends of the speaker cables, and twist the bare wires

of the cables together firmly so that they will not

cause short circuits.

Loosen the speaker terminals.

Insert the bare wire of the speaker cable into the gap

on the side of the terminal.

Tighten the terminal.

■

Connecting extra speakers

The EXTRA SP jacks can connect to the following speakers.

Press down the tab and insert the bare end of the

speaker cable into the hole in the terminal.

Release the tab to secure the wire.

SPIMP.-8MIN

• Front L/R speakers

• Center speaker

• Surround L/R speakers

• Surround back L/R speakers

• Bi-amp connection (Front speaker L/R speakers)

FRONT

• Presence L/R speakers

• Zone2 speakers

Red: positive (+)

Black: negative (–)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 124 125

No comments

Yamaha RX-V667 Manual Page 19