Yamaha RX-V2065 Owner's Manual download pdf (Page 35)

100

31 En

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

The FM/AM tuner of this unit provides the following two

modes for tuning.

■ Frequency tuning mode

You can tune in to a desired FM/AM station by searching

or specifying its frequency.

■ Preset tuning mode

You can preset the frequencies of FM/AM stations by

registering them to specific numbers, and later just select

those numbers to tune in.

Note

• Adjust the FM/AM antennas connected to this unit for the best reception.

1 Rotate the TINPUT selector (or press

dTUNER) to select “TUNER” as the input

source.

2 Press HBAND (or eFM or eAM) to select a

band.

3 Press ITUNING l / h (or eTUNING k /

n) to specify the frequency.

The TUNED indicator on the front panel display

lights up when the tuner is tuned in to a station. The

STEREO indicator also lights up if the program being

broadcasted is in stereo.

The frequency changes in the following manner according

to how you press ITUNING l / h (or eTUNING

k / n).

When you press the key more than 1 second

The tuner searches the frequency of a station that is

detectable around the current frequency. This is effective

when the tuner can receive strong signals without any

interference. Once the search starts, release the key.

When you keep holding the key, the search continues even

when a station is detected. This is useful when you want to

tune in to a specific station.

When you press and release the key

The tuner increases or decreases the frequency in steps.

Use this method when the tuner cannot receive strong

signals and stations are skipped during the search.

• You can switch between stereo and monaural for FM broadcast in the

Option menu (page 44).

4 To tune in by direct frequency tuning, press

lNumeric keys to enter the frequency of

the station.

Notes

• When you press lNumeric keys during preset tuning, a

preset number is selected. Set tuning mode to frequency tuning

mode using ITUNING l / h (or eTUNING k / n) prior to

the operation.

• “Wrong Station!” appears on the front panel display when you

enter a frequency that is out of receivable range. Make sure that the

entered frequency is correct.

• You do not need enter zero if it comes at the end of a decimal

number. For example, enter “925” for “92.50 MHz” or “94” for

“94.00 MHz”.

You can register up to 40 FM/AM stations (Preset).

The tuner automatically detects FM stations with strong

signals and registers up to 40 stations. To register AM

stations, use manual station preset.

Note

• Only Radio Data System broadcasting stations are stored automatically

by automatic station preset.

1 Rotate the TINPUT selector (or press

dTUNER) to select “TUNER” as the input

source.

2 Press sOPTION on the remote control.

The Option menu for “TUNER” is displayed

(page 43).

3 Select “Auto Preset” and then press

jENTER.

Automatic station preset starts about 5 seconds later

from the lowest frequency upwards.

FM/AM tuning

Tuning in to the desired FM/AM station

(Frequency tuning)

STEREO

TUNED

FM92.50MHz

Registering FM/AM stations and

tuning in (Preset tuning)

Registering stations by automatic station

preset

Auto Preset

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 99 100

Comments to this Manuals

No comments

Yamaha RX-V2065 Owner's Manual Page 35

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V2065