Yamaha RX-V1065 Manual download pdf (Page 53)

51 En

English

INTRODUCTION

ADDITIONAL

INFORMATION APPENDIX

PREPARATION

BASIC

OPERATION

ADVANCED

OPERATION

This unit allows you to configure a multi-zone audio system. This feature allows you to set this unit to reproduce separate

input sources in the main zone and the second zone (Zone2). You can control this unit from the second zone using the

supplied remote control.

You need the following additional equipment to use the

multi-zone functions of this unit:

• An infrared signal receiver in the second zone.

• An infrared signal emitter in the main zone. This emitter

transmits infrared signals from the remote control to a

CD player or a DVD player, etc. in the main zone via

the infrared signal receiver in the second zone.

• An amplifier and speakers in the second zone.

• Since there are many possible ways to connect and use this unit in a

multi-zone configuration, we recommend that you consult with your

nearest authorized Yamaha dealer or service center about the Zone2

connections that best meet your requirements.

• Some Yamaha models can be directly connected to the REMOTE jacks

of this unit. You may not need use an infrared signal emitter for these

products. Up to 6 components can be connected using monaural analog

mini cables or via an IR flashers. For details about connections, see

“Transmitting/receiving remote control signals” (page 17).

Connect an amplifier/receiver in the second zone and

other components to this unit as follows.

Note

• To avoid unexpected noise, DO NOT USE the Zone2 feature with CDs

encoded in DTS.

Connect the speakers in the second zone to the EXTRA

SP terminals and then set “Extra Speaker Assignment” to

“Zone2” (page 46).

• You can use the speakers connected to EXTRA SP terminals as the front

speaker system of another zone.

• When you use the internal amplifiers for the Zone2 speakers, you can

adjust the volume level and set the initial volume and maximum volume

of the Zone2 speakers (page 50).

Using multi-zone configuration

Only analog signal can be sent to the second zone. If you want to output sounds to Zone2, connect an external

component to the AV5-6, AUDIO1-2 or VIDEO AUX (AUDIO) jacks (by analog connection). For example, if you

want to output sound from an HDMI DVD player to the second zone, you must connect the HDMI DVD player to this

unit by both HDMI and analog connections.

Connecting Zone2

Using an external amplifier

To the REMOTE IN jack

Infrared signal

emitter

DVD player (etc.)

Amplifier

Remote control

Second zone

(Zone2)

Main zone

This unit

From the ZONE2 OUT jacks

Infrared signal

receiver

From the REMOTE OUT jack

Using the internal amplifier of this unit

Important safety notice

The EXTRA SP terminals of this unit should not be

connected to a Passive Loudspeaker Selector Box or

more than one loudspeaker per channel.

Connection to a Passive Loudspeaker Selector Box or

multiple speakers per channel could create an

abnormally low impedance load resulting in amplifier

damage. See this owner’s manual for correct usage.

Compliance with minimum speaker impedance

information for all channels must be maintained at all

times. This information is found on the back panel of

your unit.

EXTRA SP

ZONE2/PRESENCE

Second zone

(Zone2)

This unit

Main zone

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 155 156

Comments to this Manuals

No comments

Yamaha RX-V1065 Manual Page 53

Comments to this Manuals

Related products and manuals for AV receivers Yamaha RX-V1065