Yamaha RX-V1065 Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 156
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
19 En
Connections
English
INTRODUCTION
ADDITIONAL
INFORMATION APPENDIX
PREPARATION
BASIC
OPERATION
ADVANCED
OPERATION
Select the switch position according to your local voltage
using a straight slot screwdriver.
[General model]
Voltages are AC 110/120/220/230-240 V, 50/60 Hz.
[Asia model]
Voltages are AC 220/230-240 V, 50/60 Hz.
After all connections are complete, plug the AC power
cable of this unit into an AC wall outlet.
1 Press KMAIN ZONE ON/OFF on the front
panel (or pPOWER on the remote control)
to turn on this unit.
2 Press KMAIN ZONE ON/OFF (or
pPOWER) again to turn off this unit
(standby mode).
y
The unit needs a few seconds until ready to play back.
You can also turn on this unit by pressing PSCENE (or hSCENE).
This unit consumes a small amount of electricity even in the standby
mode. We recommend disconnecting the power cable from the AC wall
outlet.
Connecting the power cable
VOLTAGE SELECTOR
Caution
The VOLTAGE SELECTOR on the rear panel of this
unit must be set for your local voltage BEFORE
plugging the power cable into the AC wall outlet.
Improper setting of the VOLTAGE SELECTOR may
cause damage to this unit and create a potential fire
hazard.
Connecting the AC power cable
Turning this unit on and off
Caution
Do not unplug this unit while it is turned on. Doing so
may damage this unit or cause the settings of this unit
to be saved incorrectly.
230-
240V
VOLTAGE
SELECTOR
Voltage indication
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 155 156

Comments to this Manuals

No comments