Yamaha RX-A820 Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 161
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
PREPARATIONS Connecting speakers En 18
7.1-channel system
(using presence speakers)
6.1-channel system
Connecting speaker cables
Speaker cables have two wires. One is for connecting
the negative (-) terminal of the unit and the speaker, and
the other is for the positive (+) terminal. If the wires are
colored to prevent confusion, connect the black wire to
the negative and the other wire to the positive terminal.
a Remove approximately 10 mm (3/8”) of insulation from
the ends of the speaker cable and twist the bare wires of
the cable firmly together.
b Loosen the speaker terminal.
c Insert the bare wires of the cable into the gap on the side
(upper right or bottom left) of the terminal.
d Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Australia and General models only)
a Tighten the speaker terminal.
b Insert a banana plug into the end of the terminal.
Connecting the subwoofer
Use an audio pin cable to connect the subwoofer.
FRONT CENTER SURROUND
SINGLE
AC IN
SURROUND BACK/BI AMP
ZONE 2/PRESENCE
EXTRA SP
AUDIO
OUT
ZONE 2
OUT
FRONT
SURROUND SUR. BACK
PRE OUT
SINGLE CENTER
SUBWOOFER
12
SPEAKERS
12
3
45
9
QW
The unit (rear)
FRONT CENTER SURROUND
SINGLE
AC IN
SURROUND BACK/BI AMP
ZONE 2/PRESENCE
EXTRA SP
AUDIO
OUT
ZONE 2
OUT
FRONT
SURROUND SUR. BACK
PRE OUT
SINGLE CENTER
SUBWOOFER
12
SPEAKERS
12
3
45
9
8
The unit (rear)
When using only one surround back speaker, connect it
to the SINGLE jack (L side).
FRONT
aa
b
d
c
+ (red)
- (black)
a
b
Banana plug
Audio pin cable
1 2
Speaker connections
3 4 5 6 7 8 9 10
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 160 161

Comments to this Manuals

No comments