Yamaha MCR-550 Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 70
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
TROUBLESHOOTING
18 En
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod (see
page 9).
Radio reception
Problem Cause Remedy page
FM stereo reception is
noisy.
The antenna is connected improperly. Check the antenna connections.
8
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
Try using a high-quality directional FM antenna.
Switch to monaural mode.
13
The desired station
cannot be tuned into
with the automatic
tuning method.
The signal is too weak. Use a high-quality directional FM antenna.
Use the manual tuning method.
13
The preset selecting
function does not
work.
The preset (memory) may have been
erased.
Preset radio stations again.
13
There is distortion,
and clear reception
cannot be obtained
even with a good FM
antenna or an outdoor
antenna.
Multipath reflection or other radio
interference may have occurred.
Change the height, direction, or placement of the
antenna.
iPod
Note
Status message Cause Remedy page
iPod Connecting
iPod Charging
This unit is in the middle of recognizing
the connection with your iPod.
If the message continues to appear in the front panel
display and playback does not start, connect the iPod
again.
Unknown iPod
There is a problem with the signal path
from your iPod to this unit.
Connect the iPod again.
9
The iPod being used is not supported by
this unit.
Only iPod (5th generation), iPod classic, iPod nano,
and iPod touch are supported.
The iPod software is out of date. Update the iPod software version to the latest.
iPod
The play back of the iPod is finished.
For example, all the songs in the
selected album have finished being
played back.
iPod Unplugged
Your iPod was removed from the iPod
dock.
Station your iPod back in the iPod dock.
9
iPod OverCurrent
The connected iPod is not playable on
this unit. The iPod is connected at an
angle.
Disconnect the iPod. Change input source other than
iPod and select iPod as input source again. Then
connect playable iPod again.
9
Problem Cause Remedy page
No sound. The power of the unit is off. Connect the power cable correctly.
The iPod software version has not been
updated.
Download the latest iTunes software to update the
iPod software version to the latest.
The iPod is in the process of connecting
with the unit.
Please wait for a while.
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 69 70

Comments to this Manuals

No comments